![background image](http://html1.mh-extra.com/html/amica/avi-240-x/avi-240-x_operating-instructions-manual_2932628014.webp)
- 14 -
•
To check the current temperature inside the chamber, press and hold
or for 3 seconds and the display will show the current tempera
-
ture. After 5 seconds, the set (target) temperature will be shown on
the display.
•
The display is flashing — the temperature inside the refrigerator is
shown. The display is steady — the set (target) temperature is shown.
Set the temperature — two-zone refrigerator
Press to adjust the temperature in the upper refrigeration zone by
1°C**
Press to adjust the temperature in the lower refrigeration zone by
1°C**
The range of temperature that can be set varies as follows:
Upper zone: 5-10°C
Lower zone: 10-18°C
•
Each time the button is pressed, the temperature in the zone increas
-
es by 1°C. When the temperature reaches the upper limit (10°C for
the upper zone or 18°C for the lower zone), the temperature will
cycle back to the lowest possible setting, ie 5°C for the upper zone or
10°C for the lower zone.
•
To check the current temperature inside the chamber, press and hold
for 3 seconds (for the upper zone) or for the lower zone. The
display will show the current temperature. After 5 seconds, the set
(target) temperature will be shown on the display.
•
The display is flashing — the temperature inside the refrigerator is
shown. The display is steady — the set (target) temperature is shown.
Note:
•
If the appliance is disconnected from the power supply or if there is
a power outage, wait 3 to 5 minutes before reconnecting the appli
-
ance to the power supply. It will not be possible to start the appliance
earlier.
•
When you plug in the appliance for the first time, there may be a dif
-
ference between the temperature shown on the display and the ac
-
tual temperature. This is normal and after a few hours of operation,
the temperature displayed should be accurate.
Save settings function
If power will lose, the set temperature values will be remembered until
the power returns.
Open door alarm
If you forget to close the door or it is closed incorrectly, after 5 minutes
the appliance will beep. Close the door correctly.
The wrong temperature alarm
If the temperature inside the chamber is higher than 23°C, the display
shows “HI”, an hour later an beep signal will appear. If the temperature
drops below 0°C inside the chamber, the display shows “LO” and the
alarm will sound.
Summary of Contents for AVI 240 X
