AMI M920 Series, User Manual

Page: 32 / 47

Mainboard User’s Manual
S.M.A.R.T. for
Hard Disks Enable this item if any IDE hard disks
support the S.M.A.R.T. (Self-
Monitoring, Analysis and Reporting
Technology) feature.
BootUp Num-
Lock This item determines if the Num Lock
key is active or inactive at system start-
up time.
Floppy Drive
Swap If you have two diskette drives installed
and you enable this item, drive A
becomes drive B and drive B becomes
drive A.
Floppy Drive
Seek If you enable this item, your system will
check all floppy disk drives at start up.
Disable this item unless you are using an
old 360KB drive.
PS/2 Mouse
Support Enable this item if you plan to use a PS/2
mouse.
Password Check If you have entered a password for the
system, use this item to determine, if the
password is required to enter the Setup
Utility (
Setup ) or required both at start-
up and to enter the Setup Utility
(
Always ).
Boot to OS/2 >
64MB Enable this item if you are booting the
OS/2 operating system and you have
more than 64MB of system memory
installed.
L1/L2 Cache Leave these items enabled since all the
processors that can be installed on this
board have internal L1/L2 cache
memory.
System BIOS
Cacheable If you enable this item, a segment of the
system BIOS will be copied to main
memory for faster execution.
SDRAM Timing
By SPD This item allows you to enable or disable
the SDRAM timing defined by the Serial
Presence Detect electrical.
SDRAM
Frequency This item determines frequency of
SDRAM memory.
28