Rev1 0420 P/N 911-016662
7
1.
SWITCH ON THE DEVICE
Press the “On/Scan” button, one second after the screen panel in full display, it will enter the standby
mode with the sign “---
℃
” or “---
℉
”.
Then press the “On/Scan” button again, you will get the measuring result in 1 second. But if there is
no more operation, it will turn off in 30 seconds automatically.
2.
TEMPERATURE MODE SETTING
a. Press
“
MODE
”
button, and the screen will display: Body ...
℃
.
b. Press again “MODE” button and the screen will display : Room ...
℃
.
c. Press again “MODE” button and the screen will display: Surface Temp ...
℃
.
Note: The thermometer default is set to BODY mode.
Important!
The surface temperature differs from the internal body temperature. To obtain the internal temperature,
always use the “BODY” mode. Please make sure to select “SURFACE TEMP” mode for an external
area reading.
3.
F1:CHOOSING THE TEMPERATURE UNIT
In the switch on state, press “MODE” button for 2 seconds, the screen will display “F1”, the press
“MODE” button to transfer between degree Celsius and Fahrenheit, Confirm by pressing “MEM”
button.
4.
F2:ALARM SETUP
In the switch on state, press “MEM” (Memory) button, which will then display the last temperature,
and allows for a view of the last 32 measurements.
In the switch on state, Press “MEM” button again, the display will show “CLr”
5.
In the switch on state, press the “MEM” button, the screen will display the last measured data, and
can review up to 32 groups of the data. Press the “MEM” button for 5 seconds, all current memory
data will be cleared, and restore to the factory setting.
6.
In the switch on state, press “ ” can open or close the buzzer.
When the screen shows “ON”, the buzzer opened.
When the screen shows “OFF”, the buzzer closed.
7. Recalibration of device via the F4 MENU
When there is the difference between 016-662 and mercury thermometer, and you believe mercury
