2-13
TROUBLESHOOTING
S-101
Revised 09/2004
e-mail: [email protected]; [email protected]; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
TABLE OF CONTENTS
Sheet
TROUBLE DIGEST ............................................................................................................ 2-1
PRELIMINARY REMARKS ............................................................................................... 2-1
1. Machine fails to start ........................................................................................... 2-2
2. Machine started, ran a short distance and stopped ............................................... 2-2
3. Machine stuck tight through interference .............................................................. 2-2
4. Stitching operation fails to start or has started and stopped .................................. 2-3
5. Feeding uneven .................................................................................................. 2-3
6. Machine turning hard at eye ................................................................................ 2-3
7. Stop motion of stitching mechanism does not stop properly .................................. 2-3
8. Noise in stop motion ........................................................................................... 2-4
9. Cutting lever stitching .......................................................................................... 2-4
10. Machine does not stop at its most forward position or there is a clicking noise
at finish of cycle ...................................................................................................... 2-4
11. Machine repeats cycle ...................................................................................... 2-4
12. Machine completes full cycle but does not stitch ................................................ 2-4
13. Machine stitches a short distance and stops. Then completes cycle .................... 2-5
14. Clamping and unclamping ................................................................................. 2-5
15. Clamp pressure uneven or insufficient after adjustment ....................................... 2-5
16. Clamp spreading uneven ................................................................................... 2-5
17. Machine not cutting properly ............................................................................. 2-5
18. Cutting unevenly ............................................................................................... 2-5
19. Cutting stitches on a cut after machine ............................................................... 2-5
20. Distortion of eye ............................................................................................... 2-6
21. Skipping stitches ............................................................................................... 2-6