BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL YAK 11
ENG
LISH
23
amewi.com
+49 180 5009821
(Landline 14Ct/Min, Mobile max. 42Ct/Min)
Now connect the two landing flaps, aileron and landing gear
with the enclosed Y-cables. If there are enough channels at the
receiver, you can also dispense with the Y-cables, to be able to
trim the individual servos more precisely. In this case,
however, mixers need to be programmed for all functions.
Stow the Y-cables in the wing and make sure that about 10-15
cm servo-cables protrude on the right side in the direction of
flight. Fasten the cables with adhesive tape as shown in the
figure.
The control rods of the ailerons are preassembled at the
factory. Nevertheless, we recommend checking all screw
connections and securing them with Loctite if necessary. Also
use a servo-tester to check whether the servos are in the
neutral position, as illustrated. If the rudder area is now not
neutral, the linkage lengths must be adjusted.
Hook-in position of the aileron linkage:
Rudder – outermost
Servo - second hole from outside
Check the screw connections of the landing flap linkage as
described above. Move the servos of the landing flaps using a
servo-tester into a 45° position (to the end strip).
