18
amewi.com
1. When RC boat stops running, the battery must be removed.
2. After playing the boat, if any water inside the hull, then you need to pick out the
rubber stopper and tilt the boat to one side to pour out the water. Then put on
the rubber stopper and press tightly.
3. To avoid painted surfaces of the boat from getting damaged and long time
exposure to the sun. Every time after playing, you need to clean the boat and
dry the hull to make sure the boat is in good condition.
4. If the RC boat is not used for a long time, disconnect the boat battery from the
terminal and also remove the transmitter batteries to avoid leakage of the
battery as this may damage the transmitter or boat.
Maintenance and Repair
Picture 18
3. Install the rod into the second hole of
steering gear arm( picture 18).
4. Install the steering gear into its slot and lock
the press pieces and rod screws (picture 19).
Picture 19
Install the steering gear into its slot
Lock the screw
Lock rod screw
Steering gear replacement
When the steering gear is damaged, you need to take out the steering gear holder,
and pick out the defective part, then loose the steering gear arm. When install the
new steering gear, power on the boat and install the arm to the steering gear, lock
the fasten parts, then it’s ok to play.
1. Disassemble the rod screw, and then loose the steering gear press part and
take out the steering gear.(Picture 16)
2. When the new steering gear is powered on, install the arm and fasten the screw,
please take care of the vertical degree( picture 17).
(There is some tolerance which is normal)
Picture 17
Picture 16
Rod screw
Steering gear holder screws
Summary of Contents for 26088
Page 3: ...3 ...
