SW 5550A•SW 3700A•SW 1850A
General Description
Operation Manual
1-3
The SmartWave sources are true DC as well as AC power supplies. Up to 312 VRMS
are available in AC or AC+DC modes. Multi-phase models can be switched to single or
three-phased operation via the front panel or the GPIB.
A wide frequency range of DC or 40 Hz to 5 kHz is available for a broad array of
applications. Utilizing the latest in AC switch mode technology, the SmartWave has
less than -60 dB of noise and ripple with total harmonic distortion (THD) of <0.5% to
500 Hz. A crest factor of 3.25 provides high peak-to-RMS current capability. An
optional power factor correction (PFC) of .99 is also available.
1.2
Input Specifications
Input Power Ranges
: Factory configured 187 to 264 VRMS, 3 L-L (3 wire),
or 342 to 457 VRMS, 3 L-L (4 wire). A chassis ground is also required for safety.
Input Power Factor
: .6 with USA rectifier; .35 with INTL rectifier;
.99 with input PFC option.
Input Frequency Range
: 47 to 63 Hz (47 to 440 Hz for PFC input only)
Efficiency
: 70%, minimum, at full load.
Ride Through
: 3 msec, minimum; 10 msec, minimum, with PFC option.
Input Current
: Maximum currents are provided in Table 2–7 and Table 2–8.
Initial Turn-on Current Surge
: Limited to less than peak value listed in
1.3
Output Specifications: Normal Operation Mode
Calibration Interval
:
1 year.
Power Factor of Load
: 0 lagging to 0 leading.
AC or DC Output Voltage
: 0 to 156 VRMS L-N range 0; 0 to 312 VRMS L-N range 1.
Output Current Per Phase
: 16A at 115V in 156V range; 8.0A at 230V in 312V range
(1850 VA maximum).
Crest Factor
: 3.25 (peak output current to RMS output current).
Output Frequency
: DC, or 40 Hz to 5 kHz.
Output Power
: 1850 VA, maximum, per phase.
