Ametek iPac, User Manual

Page: 14 / 44

14 16040-101 Rev. J
Instrument Setup
(continued)
Charging the iPac Pachymeter
(continued)
Without a Charging Cradle
Note: Initially charge the unit for 10 hours.
Note: The Mini USB Port and the Mini USB Plug have
a flat side and a curved side. The flat side of the
Plug has a small rectangular cutout visible from the
flat side. When connecting the Plug to the Port, be
sure that the flat side of the Plug is lined up with the
flat side of the Port.
CAUTION: IF THE MINI USB PLUG IS NOT ALIGNED
PROPERLY WITH THE MINI USB PORT, THE PORT MAY
BREAK OFF AND THE PLUG MAY BECOME DAMAGED.
Note: It is important to initially charge the iPac
Pachymeter for the recommended period of time to
ensure correct operation.
Note:
The iPac comes with a mini USB port cap installed in the mini USB port hole.
This needs to be removed before charging directly.
1. Plug the A/C Adaptor with Mini USB into an appropriately volted outlet.
2. Connect the Mini USB charging cord to the iPac Pachymeter.
Power Up Mode
Pressing the Control button initiates the iPac, the display will show “Press button to
measure,” after about one minute of inactivity, the iPac will go into sleep mode, the
display will turn off. To wake up the iPac press the control button and the display will
light up.
Measurement Mode
In this mode the iPac has about 15 seconds to start the measurement
process, if no measurements are taken then the display will show
“Measurement Timeout” and then revert back to the “Press button to
measure” display.
Sleep Mode
The iPac will automatically go into a power saving sleep mode after
a period of inactivity, the display will turn off. Press the control button
to exit the sleep mode and resume operation. There is no ON/OFF
switch on this instrument.
Correct
Incorrect
Plug
Port
Plug
Port
Without Charging
Cradle