2-2 | Dycor CG1100 Oxygen Analyzer
Software
Configurator software is used to configure and calibrate the analyzer.
Requires a PC with Windows and an RS-232 serial port for single
analyzer, or Rs-485 port for multiple units on a network.
Communications
optically isolated Rs-232 (one DB-9F connector), and Rs-485 (two
DB-9F connectors)
Rs-232 selected if RTs signal is set.
Multiple units can be connected on an Rs-485 network.
Rs-485 node address is set using an externally accessible selector
switch.
Baud rate is software-selectable to 9600 or 19200 baud.
uses cg1100-compatible protocol.
I/O
DB-15 connector
(2) software-configurable alarms for oxygen, flow, and pressure
(2) additional outputs for system Fault and watchdog Alarms
4-20 mA (optionally 0-5V), optically isolated analog output for oxygen
and flow
Enclosure
8”H x 8”w x 8”D
Powder coat black finish. Clearance of at least 1/4” is required on
sides and bottom of unit for air circulation
System
Compliance
EMc Directive 2004/108/Ec En61326
safety Directive: En61010-1 Low Voltage
Emissions: En55022 conducted and Radiated
UL Classified and c-UL classified
