AMETEK Brookfield
Page 51
Manual No. M08-372-F1116
ACCESSORIES FOR FIXTURE BASE TABLE
TA-BT-KIT
FIXTURE BASE TABLE
Rectangular base table with removable insert, which is used as a test surface. All
accessories listed below mount into this table when the insert is removed. Pair of
T-Bolts for securing the table are included. Four sets of extension legs (1, 1.5, 2
& 4 Inches) are supplied. Extra extension legs may be purchased separately.
TA-BT-3KY Set of four 1 inch table leg extensions
TA-BT-2KY Set of four 1.5 inch table leg extensions
TA-BT-7KY Set of four 2 inch table leg extensions
TA-BT-8KY Set of four 4 inch table leg extensions
TA-BT-6KY Set of two thumbscrews for base table insert
ALL ACCESSORY FIXTURES BELOW MOUNT ONTO FIXTURE BASE TABLE
TA-AACC21 AACC RECOMMENDED 21mm DIAMETER PROBE
Aluminum Cylinder, 21mm D and 40mm L. Requires Fixture Table Base TA-
BT-KIT.
TA-AACC36 AACC SPEC PROBE (36mm)
This probe is used for measuring bread firmness and performing texture profile
analysis (TPA). Requires Fixture Table Base TA-BT-KIT.
TA-BLS
BILAYER SHEAR TEST FIXTURE
This fixture uses a guillotine blade to separate a bilayer tablet while measuring
shear strength. Requires Fixture Base Table TA-BT-KIT.
TA-BPS
BLISTER PACK SUPPORT TEST FIXTURE
This fixture is used to measure the force required to remove the tablet from its
blister pack. Requires Fixture Base Table TA-BT-KIT.
TA-CEF
CHEESE EXTENSIBILITY FIXTURE
This fixture measures the extensibility of a smaple, such as molten cheese, to
break point.
TA-CJ
CONFECTIONERY JIG
This fixture is used for holding candies and similar products for penetration
testing. Requires Fixture Base Table TA-BT-KIT. Consists of bases and top
plates with holes 4mm, 8mm and 12mm in diameter to allow through penetration
of samples with probes slightly smaller than holes. One blank plate (no hole) is
also included to serve as a test surface when needed.
TA-CKA
CRAFT KNIFE ADAPTER
This adapter cuts cleanly into and through material with minimum deformation
of the sample. Requires Fixture Base Table TA-BT-KIT.
TA-CLT001
CAPSULE LOOP TENSILE TEST FIXTURE
This fixture is used to measure the force required to split on half of a hard gel
capsule. Requires Fixture Base Table TA-BT-KIT.
Summary of Contents for BROOKFIELD CT3
Page 2: ......
