Ametek AMREL SPS-A Series, Operation Manual

Page: 46 / 78

Operation AMREL SPS-A Series
3-4 M550129-01 Rev A
Figure 3-2 and Figure 3-3 descriptions:
1
RS232 Connector Connector for remote control
2
SENSE Connector J3 Input connector for load voltage sensing to correct for
line drops in the load cables (see Section 3.6).
2a HV SENSE Connector
J3 Input connector for load voltage sensing, 800V models
only.
3
ANALOG CONTROL J1 I/O connector for input programming and analog output
monitoring signals as well as status indication and remote
shutdown signals. See Table 3–1 for individual pin
descriptions.
4
Configuration Switch Four–position DIP switch to configure the unit with a GPIB
option.
5
Parallel In Connector Allows master/slave configuration of up to five units when
connected to another unit’s Parallel Out connector
See Section 3.10.
6
GPIB Connector Connector for remote control.
7
Parallel Out
Connector Allows master/slave configuration of up to five units when
connected to another unit's Parallel In connector.
See Section 3.10.
8
Output Bus Bars Positive (+) and negative (–) outputs.
9
Ground Connection for ground wire.
10 AC Input Connectors
Connection for 3-phase AC.