
5
6/07
Control / Motor Starter Package (Ref: Drawing CPMS)
a) Factory installed motor starter package includes a service disconnect, motor starter,
and transformers pre-wired to the PLC. These systems require a single point
electrical connection to the service disconnect. Line service must be rated to pump
motor requirements.
Standard systems are factory set for 460V, 3ph service. Optional power supply
factory wired as ordered.
b) Wire the pump motor from the motor starter with seal tight (provided).
NOTE: If optional backwash booster pump is used and a second motor starter is
factory supplied, refer (drawing CPMS) for proper connection points.
NOTE: Do not operate pump(s) dry. Damage to pump seal and shaft may occur.
Control Package (Ref: Drawing CPIO)
a) The control package is pre-wired at factory
b) Two sets of terminals, located in the control panel, are provided for pump control.
Reference drawing CPMS for terminals.
c) Power for motorized valves is supplied from control panel terminal strip.
(See Section 1.4 for instructions).
d) Fuse holders connected to output terminals 9 & 11 are intentionally left with no
fuses.
Fuses should not be installed or removed unless specific instructions are
received from AmeriWater 800.535.5585.
Output #9 will be fused, (if applicable), at start up to convert from city water to
system water backwash.
e) Output #11 will be fused, (if applicable) to change timed backwash from 24 hours to
7 days.
Timed backwash should be changed only for systems operating on a
closed loop and only after consultation with AmeriWater.
NOTE: Changes to these options without instructions from AmeriWater may void
the filter warranty.
Summary of Contents for CW130 Series
