6
1.
CONTROLLER:
Control mechanism for the RO.
2.
PRODUCT CONDUCTIVITY SENSOR:
Cell that reads the quality of the product water.
3.
PREFILTER INLET GAUGE:
Gauge measuring the water pressure on the filter inlet in PSI.
4.
PREFILTER OUTLET GAUGE:
Gauge measuring the water pressure on the
filter outlet in PSI.
5.
SYSTEM PRE-FILTER:
Pre-filter for the system to remove particulate from the water prior
to the RO system.
6.
INCOMING TAP WATER
: Connection point for the incoming tap water.
7.
INLET SOLENOID:
Opens when the RO system is on to allow water to feed through the
system, closes when the system is OFF.
8.
CIP CONNECTIONS:
Connections for the optional membrane clean in place system.
9.
FILTER SAMPLE PORT:
Used to check the quality of water after the pre-filter.
10
.
INCOMING CONDUCTIVITY SENSOR:
Cell that reads the quality of the feed water.
11.
LOW PRESSURE SWITCH:
Switch to protect the pump if there is low feed pressure.
12.
PUMP THROTTLE VALVE:
Valve that is used to throttle the output of the pump.
13.
REJECT PSI:
Gauge that measures the pressure of the water coming from reject side of
the membranes in PSI.
14.
REJECT THROTTLE VALVE:
Valve that can be used to control the reject flow.
15.
PRODUCT FLOW METER:
Measures the flow of the Product Water in gallons per minute
(GPM).
16.
REJECT FLOW METER:
Measures the water being sent to the drain, in gallons per
minute (GPM).
17.
PUMP:
Provides the driving pressure for the reverse osmosis system.
18.
MEMBRANE ASSEMBLY:
Membrane for reverse osmosis.
19
.
PUMP PSI GAUGE:
Gauge that measures the discharge of the pump in PSI.
Summary of Contents for 00HRO64800
