© American Time
10
SQA461RSxE Owner's Manual
A
pp
e
nd
ix
M
ai
n
te
n
a
n
ce
Co
de
B
lue
O
p
e
rat
io
n
In
st
a
ll
at
io
n
D
e
scr
ip
ti
o
n
Operation
Powering Up
Before applying power, place the SET/RUN switch to the RUN position and the UP/DOWN/CLOCK switch to the CLOCK position.
Apply power to the unit. The displays may rotate during the power on self test and then a version number will appear for a few
seconds. Once the receiver inside the clock receives a signal from the SiteSync IQ system controller, the clock will display and
begin keeping time. At first startup the clock may display a time such as 1:00:00 until it receives the first time update from the
SiteSync IQ system controller. This should only take a few seconds, after which the correct time from the SiteSync IQ system
controller should appear.
Setting Time
Setting of the time is not needed for the digital clock or timer control station. The time information is automatically updated
by the SiteSync IQ system controller. The 12- or 24-hour mode option is configured by the display settings of the system
controller.
The ATSTCS timer control station will allow the user to set a 12- or 24-hour mode and time when the SET/RUN switch is in the
SET position. However, as soon as the SiteSync IQ system controller updates the 12/24 hour mode chosen, the time will be
reset to the time sent by the SiteSync IQ system controller and the 12/24 hour mode configured in the system controller. Set
the SET/RUN switch to the RUN position and the UP/DOWN/CLOCK switch to the CLOCK position to return the clock display.
Setting the Up Counter Preset Time
If you want to use the alarm and hold feature with the UP timer, you will need to set a preset time for the UP timer.
Set the UP/DOWN/CLOCK switch to the UP position.
Set the SET/RUN switch to the SET position. The hours digits will be flashing.
Using the INCREMENT switch, set the desired hours for the preset time, then press ENTER. The minutes digits will now be
flashing.
Set the desired minutes the same way, then press ENTER. The seconds digits will then be flashing.
Set the desired seconds the same way, then press ENTER. The display will then flash
donE
.
Set the SET/RUN switch back to the RUN position.
Note:
A preset of 00:00:00 allows the digital clock/timer to be used as a standard elapsed timer with a maximum elapsed time
of 30:59:59.
