10
M965652 Rev. 1.9 (3/19)
Fig.6
F
GENERAL CLEANING; Fig. 5
1.
For general cleaning use a damp, soft cloth to clean
the spout and the sensor.
2.
For cleaning dirt use a soft cloth with diluted dish
washing detergent. Wipe the area using a wet cloth
and dry using a soft cloth.
Avoid using anything that may scratch the spout surface
.
Never use polishing power, detergent or a nylon scrub brush.
They will damage the surface of the spout or Sensor.
CAUTION
Do not scratch the sensor when cleaning. Avoid using
any abrasives or harsh detergents or chemicals.
FAQ’S
Q:
How will I know if the battery needs to be replaced?
A:
Valve will not open and sensor will continuously blink 2 times interrupted by a pause, for up to 7 days.
Q:
Why has the flow rate of the faucet reduced significantly?
A:
The
filter assembly, flow regulator or areator/spray may be clogged. Check and clean. Refer to
Start-up/Maintenance, sections C, D and E.
Q:
Why doesn’t water flow out of faucet when I’m within the sensor detection zone?
A:
Battery may need replacement. If sensor continuously blinks 2 times interrupted by pause, replace battery
or call (844) CRT-TEAM / (844) 278-8326.Z
Q:
What is the normal operating pressure range?
A:
Faucet will operate with supply pressures ranging from 20-80 psi.
