SERVICE
To change direction of handle
rotation, proceed
as follows:
Turn valve to OFF position.
Remove HANDLE and
ADAPTER if present.
Remove SPRING CLIP (1).
Lift STOP WASHER (2),
turn 90
°
and replace.
Replace SPRING CLIP (1).
Replace HANDLE ASSEMBLY.
90
°
WATER SUPPLY CONNECTIONS
7
Cold
Connect water supplies to FAUCET (1) with 1/2" IPS
FLEXIBLE SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3).
Use adjustable wrench to tighten connections.
Do not over tighten. Be careful not to kink copper supply
when bending. Use tubing cutter to cut to proper length.
FERRULE
COUPLING NUT
NOTE: FLEXIBLE SUPPLIES ARE NOT INCLUDED AND HAVE
TO BE PURCHASED SEPARATELY
8
FINISH DRAIN INSTALLATION
Position EXTENSION ROD (1) onto POP-UP ROD (2) and tighten
THUMBSCREW (3).
Position BIDET fixture and secure to floor.
Insert lift rod into lift rod guide.
Using metal TAILPIECE (5), make connection to the TRAP (6).
Remove one end of CLIP (4) from PIVOT ROD (7) by squeezing ends
together while sliding.
Insert PIVOT ROD (7) into second or third hole in EXTENSION ROD (1)
and reassemble CLIP (4). (EXTENSION ROD (1) may need to be bent.)
Adjust STOPPER height by repositioning EXTENSION ROD (1) and
tightening THUMBSCREW (3).
3
3
1
1
2
1
1
7
4
6
5
2
2
Replace SPRAY (3) and operate
handles several times from
OFF to ON position. Do not
force, handles turn only 90˚.
SPRAY (3) may accumulate dirt
causing distorted and reduced
water flow. Unscrew and remove
SPRAY (3) and rinse clean.
3
M 9 6 8 2 9 2
Operate Lift Rod (3) and fill
Bidet with water. Check that
DRAIN STOPPER (4) makes
a good seal and retains
water in Bidet. Adjust
stopper height by
repositioning Lift Rod (3) and
tightening Thumbscrew (5).
Release DRAIN STOPPER (4) and
check all drain connections for
leaks. Tighten if necessary.
9
TEST INSTALLED FITTING
With HANDLES (1) in OFF
position, turn on WATER
SUPPLIES (2) and check all
connections for leaks.
Operate both handles to flush
water lines thoroughly. Turn
DIVERTOR (6) to rim wash and
bidet spray.
1
3
5
2
2
6
11
10
DO: SIMPLY RINSE THE PRODUCT CLEAN
WITH CLEAR WATER. DRY WITH A SOFT
COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT
WITH SOAPS, ACID, POLISH, ABRASIVES,
HARSH CLEANERS, OR A CLOTH WITH A
COARSE SURFACE
CARE INSTRUCTIONS:
4