- 2 -
2
3
4
• Operate LIFT KNOB
(1)
to verify that
STOPPER
(2)
opens and closes.
CHECK OPERATION OF POP-UP
MAKE WATER SUPPLY AND WASTE CONNECTIONS
M965766 (8/16)
• Push TAIL PIECE
(11)
down into TRAP
(C)
(threaded end up).
• Thread LOCKNUT
(5)
, WASHER
(4)
and GASKET
(3)
(Bevel side up) onto DRAIN BODY
(10)
.
• Apply a bead of PUTTY
(D)
to underside of FLANGE
(2)
.
• Feed DRAIN BODY
(10)
up through SINK
(A)
and thread
the FLANGE
(2)
fully onto DRAIN BODY
(10)
.
• Tighten LOCKNUT
(5)
firmly, keeping the pivot rod hole pointed
towards the back of the sink.
• Assemble PIVOT ROD
(9)
as shown in
Figure-2a.
Notice the position of the CONCAVE WASHER
(G)
.
• Insert PIVOT ROD
(9)
into DRAIN BODY
(10)
and tighten
PIVOT NUT
(F)
.
• Pull TAIL PIECE
(11)
up and thread tightly into
DRAIN BODY
(10)
.
• Position EXTENSION ROD
(7)
onto POP-UP ROD
(E)
and tighten
THUMBSCREW
(6)
.
• Remove one end of CLIP
(8)
from PIVOT ROD
(9)
by squeezing ENDS TOGETHER WHILE SLIDING.
• Insert PIVOT ROD
(9)
into second or third hole in EXTENSION ROD
(7)
and reassemble CLIP
(8)
.
• DROP STOPPER
(1)
into DRAIN BODY
(10)
.
• Adjust stopper height by repositioning EXTENSION ROD
(7)
and tightening THUMBSCREW
(6)
.
INSTALL POP-UP DRAIN
1
APPROX. 20"
2
COLD
HOT
3/8" COMPRESSION
RED
BAND
BLUE
BAND
• Connect FLEXIBLE SUPPLIES
(1, 2)
directly to wall supplies.
Connection on fitting supplies are 3/8
"
compression.
Connect left SUPPLY
(1)
to Hot (Marked with a Red Band)
and right supply to COLD
(2)
wall supply.
• Faucet supplies are 20
"
long from faucet base.
Note: If additional supply length is required, installer must
purchase additional parts separately.
Important: If SUPPLY HOSES (1, 2) are to long, loop as
illustrated to avoid kinking.
• Connect 1-1/4” O.D. tailpiece on POP-UP DRAIN to
waste outlet.
1-1/4"
6
E
D
7
8
9
C
F
2
A
1
3
4
5
10
11
2a
F
G
2
1
P-2, P-2B - 7075.050