6
7301793-100 Rev. C
16
INSTALL SINK APRON
1. Hold APRON up against SINK and flush against finished wall.
2. Mark a line with a pencil on the wall about 6" long as shown on
both sides of the APRON..
3. Remove the APRON. Clean the wall where the APRON
BRACKETS supplied with SINK are to be applied. Peel off the
protective strip from the back of the APRON BRACKETS. Apply the
two APRON BRACKETS to the finished wall parallel to the pencil
marks as shown in the illustration below.
OPTIONAL MOUNTING. (SCREWS AND ANCHORS NOT
SUPPLIED) Use Brackets to mark pilot holes on wall. Drill holes for
ANCHORS. Peel off the protective strip from the back of the APRON
BRACKETS. Apply the two APRON BRACKETS to the finished wall
parallel to the pencil marks as shown and aligned with the mounting holes.
See illustration below. Install SCREWS and tighten.
4. Clean off the pencil marks from wall.
6"
(152mm)
APRON
SINK
6. Retain APRON with THUMB NUT. Finger tight only.
5. Position APRON under SINK and against finished wall alinging
EYEBOLT with hole in APRON.
THUMB NUT
EYEBOLT
APRON
APRON
IMPORTANT: SAVE ALL INSTALLATION INSTRUCTIONS FOR FUTURE USE
1/2"
(13mm)
PENCIL MARK
APRON
CLEAN WALL
PROTECTIVE
STRIP
