Owner’s Manual
Wood Chip Smoker
13592 Desmond St., Pacoima, CA 91331 818.897.0808 tel 888.753.9898 toll free www.americanrange.com
8
WARNING
!
When water is at a high temperature and high pressure, excessive splashing of
hot water may occur that could result in injury.
CASTER INSTALLATION
When installing provided casters, match holes on the caster with holes on the oven bottom base and fasten with the hardware
provided. Locking-type casters must be installed in the front.
Ovens with casters
must be installed with the locking front casters supplied, a flexible connector complying with ANSI Z21.69.
CGA6.16 and a quick-disconnect device complying with ANSI Z21.41CGA 6.9. Adequate means must be provided to limit the
movement of the appliance without depending on the connector and the quick-disconnect device or its associated piping to limit the
appliance movement.
LEVELING
A carpenter’s spirit level should be placed on the oven floor, and the unit leveled both front-to-back and side-to-side. If the unit is not
level, cakes, casseroles and any other liquid or semi-liquid batter will not bake evenly, burner combustion may become erratic, and the
unit will not function properly.
If the kitchen floor is relatively smooth and level, the unit may be leveled by turning the "foot" section of the leg, since casters are not
adjustable. Identify the high corner and level the unit if the adjustment required exceeds the 1-1/4" limit use metal shims.
CHECK OPERATION
All American Range Corporation appliances are adjusted and tested before leaving the factory, effectively matching them to
appropriate atmospheric conditions. We recommend that adjustments and calibrations are performed upon installation to assure
proper operation of the unit and avoid possible problems caused by rough handling or vibration during shipment. This work must be
performed only by qualified service personnel. These adjustments are the responsibility of the customer and/or dealer and are not
covered by warranty.
Check all gas connections for leaks with a soapy water solution before lighting the oven.
DO NOT USE AN OPEN FLAME TO
CHECK FOR LEAKS!
Putting an open flame beside a new gas connection is extremely dangerous and may result in serious injury
or death.
