26
16599 rev. B pub. 11/07/2017
section 4
maintenance
1
2
14
13
3
4
5
6
7
8
10
11 12
9
9
9
Exploded view of the pulley 0600
(ALM part number 2-20662)
NEVER HIT THE DRIVE PULLEY WITH A HAMMER OR OTHER TOOL TO
REMOVE THE PULLEY OFF THE VEHICLE PTO .
Mark the direction of Belt Rotation
DRIVETRAIN MAINTENANCE CONT .
Ref Description
Qty
1 Fixed Flange
1
2 Sliding Flange
1
3 Washer
1
4 Spring Seat
1
5 Spring
1
6 Washer
1
7 Spring Cover
1
8
Snap Ring
1
9
Block Assembly
3
10 Cap
1
11 Flat Washer
1
12 Nut
1
13 Block
3
14 Weight
3
2 .
Taper Shaft -
Remove the fixed flange using the puller suited for the pulley .
Screw in the puller until the pulley is freed from the engine shaft .
3 .
Straight Shaft -
Remove the fixed flange by pulling .
Pulley removal from the vehicle
Cleaning the pulley
Cleaning the cap
Removing the cap and block centrifugal
Remove the nut (12) and washer (11) . Cap and centrifugal blocks are now released .
Pulley which nut and washer are removed
Pulley with the cap are removed
Before cleaning cap
1 . Remove the bolt from the engine crankshaft .
1 . Clean the cap with compressed air .
2 . Clean to remove any dust or dirt that can remain on the cap .
3 . Pass a scrubbing pad of very fine grade on the cap .
4 . Clean the cap with a solvent (brake cleaner) and a cloth .
5 . Clean again the parts with compressed air .
Not to unbalance the pulley, it is best to note the location of the
centrifugal blocks in order to place them in the same location
during reassembly .
