17265
Disconnect the bullet connectors on the power supply and route through
the hole in the side of the dash. Once the supply is through the hole,
reconnect the bullet connectors. See figure 8.
Route the supply along the rest of the wiring in the dash to the passen-
ger side of the passenger dash support, then down to the power block.
Trim the excess from the zip ties once secured. See figure 9.
If you plan to use the JVC or headphone jack, secure them to the
crossmember. If you don’t plan to use them, they can be tucked behind
the sidebar, and secured with a zip tie. See figure 11.
Turn the unit key to the “run” position and power on the soundbar. Connect to your Bluetooth device and ensure that the
soundbar is functioning properly. Once connections are verified, replace the cover for the power block and the unit’s hood
to complete your installation.
figure 8
figure 9
figure 10
figure 11
STEP 8
Connect the spade terminals to the power block according to the
included wire diagram. See figure 10.
STEP 10
STEP 9
STEP 11
TERMINAL BLOCK ORIENTATION BENEATH HOOD
driver side
GROUND 12V –
(ground-black)
SWITCHED 12V +
(yellow)
CONSTANT 12V +
(red)
1
2
3
4
5
6
1
2
3
4
5
6
