RM4200 Series User Guide
Optional Installations
59
Installing the Adjustable Mounting Bracket
RM4210 or RM4211 units can be installed on a pole or a flat surface by using an adjustable mounting bracket.
This option may be used if the unit is not installed on a test station or if the installation location has limited
satellite reception. The unit is attached to the bracket with a flat base adapter. The bracket can be angled and
adjusted to receive optimum satellite signal.
W
ARNING
:
Equipment intended to be mounted on a wall or ceiling shall withstand a force of four times (4x) the
weight of the equipment.
Complete the following steps to install an RM4210 or RM4211 on an adjustable bracket with a flat base adapter.
1
Install the flat base adapter onto the adjustable bracket.
2
Install the liquid tight fitting into the center of the flat base adapter (from the underside).
Figure B-9. Flat Base Adapter and Conduit Pass Through Installed
3
Mount the adapter and bracket on an available surface using the provided mounting hardware.
4
Thread input wires through the fitting on the flat base adapter.
5
Place the unit on the flat base adapter, lining up the screws.
I
MPORTANT
:
Do not twist the dome on the adapter if the screws do not line up with the cut-outs. Lift
the dome off of the adapter and replace in correct position.
6
Secure the unit by tightening the screws.
