American Flame AFVK-SP Valve Kits
REV. 10-8-19 Page 7
INSTALLING BATTERIES INTO THE VALVE KIT BATTERY PACK
The battery pack is located at the back of the valve kit inside the metal box with the heat shield. See Fig. 14.
1. The valve kits battery pack has a 6-inch, 4-pin wire harness connecting the battery pack to the module. See Fig. 16.
2. Prior to installation remove the battery pack during installation and install (4) AA batteries.
3. Install the heat shield ovetop of the battery pack and slide it back into the back of the valve box. See Fig. 14.
Note:
All valve kits are battery powered systems and will not operate without the battery pack. The battery pack controls
the solenoid or motor drive in the system and provides the power necessary to operate each valve kit.
AFVK-SP, AFVK-SP-HL, & AFVK-SP-MHL MODELS:
The battery pack is located at the back of the valve kit inside the
metal box with the heat shield. See Fig. 14. Install (4) AA alkaline batteries in the battery pack as shown in Fig. 15.
1. The 6-inch, 4-pin male connector on the battery pack comes pre-installed to the 4-pin female connector located on the
battery pack and module.
Note
: Figs. 14 & 16 for reference.
2. The AFVK-SP-HL & AFVK-SP-MHL also has (2) 18” wires (Red & Black) that are connected to the Hi/ Lo solenoid.
Reference Figs. 11, 16 & 17.
3. After the valve kit installation process is completed reinstall heat shield and battery pack back into the rear area of the
metal box as shown in Fig. 14.
4. Ensure the excess wire from the 4-pin wire harness and Hi/Lo wire harness are tucked in the metal box to protect
them from heat.
Requires (4) AA 1.5V
Alkaline Batteries
Batt
ery c
over
slid
es o
n/off
La
tc
hin
g S
ole
no
id
D
C
M
oto
r D
riv
e
Fig. 15
Install (4) AA batteries into the battery pack.
Learn Button
(behind battery pack)
AFVK-SP BACK VIEW
Battery Pack
(4-Pin Connector
into module)
Battery Pack
(shown as dotted line
in front of module)
C
on
tr
ol M
odule
G
as V
alv
e
Gas Outlet
Pilot Tube
Connection
Gas Inlet
Fig. 14
Battery pack location.
4-Pin Connector
Red & Black Wires
BACK OF BATTERY PACK
Screw Terminals
(secure red & black wires)
Latching Solenoid
DC Motor Drive
Black
Red
Wires attach to
Solenoid or
Motor Drive
Fig. 16
4-pin connector on back of battery pack.
Fig. 17
Red & Black wires out out of battery pack.
