INDOOR INSTALLATION
SPEEDDOME LT
2-3
Install Kit Supplied
0351-0393-01*
a)
Washer, FL, #10 x .040THK
2
2848-8100-17
b)
Eyebolt, 10-24 x 1-3/4”L
1
2882-0112
c)
Nut, Lock, ZN, 10-24
1
2838-9154-05
d)
“S” Hook, open
2
2897-0004
e) Chain,
sash
6FT 2898-0002
* Only parts used in this procedure are listed.
Procedure
!
Shipping box contains a template—do
not throw the template out.
1. Using the template, scribe a 35.6cm (14”)*
hole in the ceiling or tile (Figure Chapter 2-
1).
Cut out the hole.
2. Secure the eyebolt.
Place a washer (a) over the eyebolt supplied (b).
Insert the eyebolt into a hole in the top of the
housing and secure using a washer and nut (c).
Figure Chapter 2-1. Hard mount
3. Connect the safety chain to the eyebolt.
Using an S-hook (d), hang safety chain (e) from a
strong ceiling member and, using a second S-hook,
attach other end of the chain to the eyebolt.
!
WARNING!
Keep chain as taut as possible! Close
ends of each S-hook!
DO NOT use sprinkler or fire control
system when securing the safety
chain!
4. Feed cables through a hole in the side of the
housing.
Feed video and multiconductor cables through one
of the two holes in the side of the housing. Then
cover all openings in the housing with the aluminum
tape supplied.
5. Insert the housing into the ceiling hole.
With the three mounting tabs of the housing in the
up position, insert the housing into the ceiling hole,
then from inside the housing bring the tabs down and
tighten their screws to secure. The housing is now
ready for chassis installation (go to “Chassis
Installation,” page 2-8).
Hard Ceiling Surface Mounting with
Adjustable Bracket
This procedure explains how to mount the dome’s
housing to a support beam or other attachment
point using safety chain and bracket. After com-
pleting this procedure, go to page 2-8 for chassis
installation.
!
WARNING!
For all ceilings except tile.
Ceilings MUST be able to hold at least
9kg (20 lbs)!
Install Kit Supplied
0351-0393-01*
i)
“S” hook, open
2
2897-0004
j)
Chain, sash
6 FT 2898-0002
* Only parts used in this procedure are listed.
Install Kit Supplied
0351-0394-01*
a) Support,
Z-shape
2
0500-3440-01
b) Support,
L-shape
2
0500-3439-01
c)
Nut, wing 10-32
8
2834-0007-01
d)
Screw, mach., M6x12
4
5801-4074-311
e) Adapter
plate
1
0500-3982-01
f) Spacer,
Nylon
16
3110-0016
g)
Washer, flat #10
8
2848-6301-23
h)
Nut, wing 10-32
8
2834-0007-01
* Only parts used in this procedure are listed.
a
Cable Access
Hole
e
b
c
Mounting
tabs
Cables
d
