SENSORRAIL IIIE ADRL3TRK SERIES
8200-0593-02, REV. A
INSTALLATION GUIDE
15 of 34
6. Note the trolley mileage by doubleclicking the
Output 2 LED at the bottom of the screen. The
monitor temporarily displays the software
version and mileage in kilometers.
Note:
Ensure rail calibration displays the correct
rail length in meters. If not, repeat this step. If
the rail length is still not correct, ensure the spot
LED on the trolley circuit board lights every time
it passes a spot label. If the LED does not light,
clean the optical encoders on the circuit board,
and if this does not work, call Technical
Support.
7. In the Matrix section, select the matrix switcher
to be used by clicking the appropriate choice.
8. In the Rail Control section, select the controller
or keyboard key that will control the trolley by
clicking “Iris” or “Focus”.
9. Check all functions (especially presets and
patterns management if validated during
installation).
10. Check optical stop detection (see CAUTION
below). The dome can be oriented to see the
function LEDs on the CPU board.
CAUTION:
Do not run the trolley at full
speed in case of detection failure.
11. Check the RS-422 data in and out LEDs on the
trolley CPU board. These LED’s can be seen
from the dome.
12. Note all failures.
14. Install the Cowling
Mirrored cowling is used to conceal the location of
the camera trolley. Grooves in the lower part of the
rail are used to secure the cowling.
Note:
The cowling is scored 10mm (0.4in) from its
edges to enable the edges to fold toward its
mirrored side. The fold allows the cowling to secure
to the rail grooves.
Note:
This is a two person job.
Tools, Equipment, and Parts Required for
this Operation
•
Proper lift equipment (scissor lift with extended
work platform is recommended)
•
Cowling
roll
•
Plastic card similar to a credit card (do not use
your personal credit card)
•
Ruler
and
cutter
•
Soft white gloves.
Procedure
With you and your helper wearing soft white
gloves:
A. Bend the long edges of the cowling toward
the mirrored side.
B. Secure the cowling.
Have your helper hold the cowling roll just under
the lower part of the structure with its mirrored
side facing down. Then using a flat plastic card,
SLOWLY and CAREFULLY insert one end of
the cowling into the groove until it is completely
secured in the rail.
CAUTION:
Ensure ends of the
cowling at the start end of the rail are
even when curved to fit in the
grooves. If not, the cowling will not
align with the grooves as you insert it.
C. Repeat Step B to insert the other end of the
cowling into the opposite groove.
Note:
Bends and waves may appear in the
cowling. These will disappear once the cowling
is completely secured.
D. Remove excess cowling.
Use a ruler and cutter to cut off excess cowling
at each end of the rail.
Trolley CPU Board
Yellow LED:
CaptA
Rail end optical
strips detection
Green LED: 5V
5V power on the
CPU board
Green LED:
CaptB 2.5m
Spots detection
Red LED:Def1
Power default
LED Def1+Def2:
CPU in boot
mode (no
firmware
loaded)
Yellow LED:
TX Rail
Yellow LED:
TX Rail
Red LED: Def2
Speed Default
(Trolley speed
close to zero)
LED Def1+Def2:
CPU in boot mode
(no firmware
loaded)
Yellow LED:
TX Rail
Yellow LED:
TX Rail
