American Dynamics RJ856UD Series Installation Manual Download Page 2

RS-422 SINGLE-POSITION JUNCTION BOX (J-BOX) 

8000-2573-20, REV. H 

INSTALLATION GUIDE 

2 of 10

 

RS-422 Single-Position  
J-Box Specifications 

REG ID: SV JBOX1 

Product Codes 

RJ856UD ..............................120V with North American 

line cord 

RJ856UD-1 ...........................230V with Continental 

European line cord 

Transformer primary jumpers and mains line cord are 
field changeable to support either 120Vac or 230Vac 

Electrical 

Power source ........................100–120Vac or 200–

240Vac. 50/60Hz 

Fuse......................................3.15A type IEC127, 

sheet III 

Max. operational limits ..........90–135Vac or 180–

265Vac, 50/60Hz 

Input current..........................1.0A/.5A 
Output ...................................26Vac, 2.4A max.  

Class 2 LPS 

Power line protection ............Gas Discharge tube 

impulse rated at 8/20µs 
impulse discharge current: 
10kA 

Operational 

Diagnostic LEDs ...................Push button controlled 

data in / data out 

Power....................................On/Off switch 
Compatible with ....................SpeedDome Ultra outdoor 

housing 

Mechanical 

Environment..........................Indoor / Outdoor 
Wall mounting options...........concrete, wood, sheet rock 
Dimensions (H x W x D)........200 x 200 x 132mm  

(7.87 x 7.87 x 5.19 in.) 

Mounting area (H x W)..........281 x 200mm  

(11 x 8 in.) 

Weight:..................................3.7 kg (8.25 lbs) 
Construction..........................Polycarbonate, non-

metallic enclosure 

Color .....................................Light gray 
Cover locks ...........................2 quick-release latches 
Cable access ........................3 ½-inch NPT strain relief 

fittings provided for power, 
host, and dome cables.  

RS-422 Communication Interface 

Cable distance: 

J-box to J-box ..................1km (3000ft) 
Host to J-box....................1km (3000ft) 
J-box to camera dome .....Limited by the length of the 

low-voltage ac power 
cable. See Table 1 on 
page 6. 

Cable type .............................2 shielded twisted pair, 

22AWG, polarized 

Surge protection....................TVS impulse rated at 

1500W, 100A, 10/1000µs 

Connectors: 

Host .................................Spring-loaded 
Aux ..................................Spring loaded 
Dome ...............................Euro-style terminal 

Environmental 

Weatherproof standard .........NEMA 4 / IP66 
Operating temperature ..........–40°C to 50°C  

(–40°F to 122°F) 

Storage temperature .............–10°C to 50°C  

(14°F to 122°F) 

Relative humidity...................0 to 95% non-condensing 

Regulatory 

EMC ......................................47 CFR, Part 15, Class A 

EN55022, Class B 

Immunity................................EN50082-1 
Safety....................................UL1950 

CSA 22.2, No. 950 
EN60950 

See additional declarations on last page. 

 

Summary of Contents for RJ856UD Series











Reviews: