TWO BAY SYSTEMS, 24 CAMERAS x 16 MONITORS
Systems for a maximum of 24 cameras and 16 monitors are
supplied in two bays. The AD1653B bay contains a power
supply, a processor, camera modules for cameras 1 through 24,
and monitor modules for monitors 1 through 8. The AD1657
bay contains a power supply, camera modules for cameras 1
through 24, and monitor modules for monitors 9 through 16.
These systems are supplied in two bays configured as shown
below:
AD1653B AD1657
Modules/Panels
Bay
Bay
AD1603N PSM, Power Panel
1
1
AD1663B CPM, Data Panel
1
-
AD1611 VIM
1-3
-
AD1609CM VIM
-
1-3
AD1626 VOM
4
1-4
For illustration of a typical Two Bay system with 24 cameras
and 16 monitors, see Page C-11 of the Typical System
Connections.
IDENTIFY ALL BAYS, MODULES, AND PANELS
CAREFULLY BEFORE PROCEEDING.
Power/Data Interconnections
Each bay contains an AD1603N Power Supply Module, thus
no power interconnection is required.
A Data Interconnect cable is supplied to provide control data to
the AD1657 bay. Connect this cable between connector J3 on
the Data Panel in the AD1653B bay and connector J3 on the
Power Panel in the AD1657 bay.
Control Code Connections
Control Code for all cameras in this configuration is provided
from connector J1 on the Power Panel in the AD1653B bay.
Video Input Connections
Each AD1609CM in the AD1657 bay has eight pairs of
looping BNC’s on the back panel for video input connections.
Video inputs are connected to one BNC of each pair and
looped to the corresponding terminated video input in the
AD1611 VIM in the AD1653B bay.
The system assigns the video input connected to the top BNC
pair on the right-most AD1609CM as input number 1, the
video input connected to the top BNC pair on the next
AD1609CM to the left as input number 9, and the video input
connected to the top BNC pair on the third AD1609CM as
input number 17, up to video input 24 on the bottom BNC pair
of the third AD1609CM.
Video Output Connections
Each AD1626 VOM in the AD1653B and AD1657 bays has
two BNC’s on the bottom of the back panel (labeled OUT) for
video output connections.
In the AD1653B bay, the system assigns the video output
connected to the upper right OUT BNC on the right-most
AD1626 VOM as video output number 1, and the video output
from the lower left OUT BNC of this VOM as video output
number 2. The video output connected to the upper right OUT
BNC on the next AD1626 VOM to the left is assigned as
output number 3, etc., up to video output number 8 on the
fourth VOM in this bay.
In the AD1657 bay, the system assigns the video output
connected to the upper right OUT BNC on the right-most
AD1626 VOM as output number 9, and the video output from
the lower left OUT BNC of this VOM as output number 10.
The video output connected to the upper right OUT BNC on
the next AD1626 VOM to the left is assigned as output number
11, etc., up to video output number 16 on the fourth VOM in
this bay.
The four top-most BNC’s on each VOM, labeled A and B, are
not used in this configuration.
AD1650B
SYSTEM CONFIGURATIONS
3-7
