NOTICE
PLAYBACK
OPERATION
RECORDING
OPERATION
PREPARATION
6
INTRODUCTION
ENGLISH
A Word on the Exclusive 3N-100AAS
Battery Pack
The nickel-cadmium battery pack (3N-100AAS) is used for
power source of the built-in clock and memory circuit.
Charging the Battery Pack
1. Turn on the power of the VTR.
2. The battery pack in the VTR is charged.
Battery Installation
Removal:
1. Remove the battery cover.
2. Disconnect the connector in the VTR.
Specification of Battery
■
Temperature
For charging
:
0
°
C to 80
°
C
For operating
:
–20
°
C to 80
°
C
For storing
:
–30
°
C to 80
°
C
■
Charging time
:
more than 48 hours
Notes:
■
Use only for this VTR.
■
Do not dispose of the batteries into fire.
■
Do not short circuit the terminals.
■
Do not modify or disassemble.
■
Avoid dropping, unnecessary shocks.
Connector
RED wire
Battery pack
Installation:
1. Install the battery pack placing the red wire upside, and
connect the connector on the battery pack to this VTR.
Make sure the polarities (+) and (–) are correct.
2. Close the battery cover.
Note:
If the Battery Pack is removed, the memory data will be
erased. In such a case, perform the setting from the first step.
