113047 - 21
9
B. LOCATION REQUIREMENTS
Before installing the dryer, be sure the location conforms to local codes and ordinances. In the absence of such
codes or ordinances the location must conform with the National Fuel Gas Code ANSI.Z223.1 LATEST
EDITION, or in Canada, the installation must conform to applicable Canadian Standards: CAN/CGA-B149.1-
M91 (Natural Gas) or CAN/CGA-B149.2-M91 (Liquid Propane [L.P.] Gas) or LATEST EDITION (for General
Installation and Gas Plumbing).
1. The dryer must be installed on a sound level floor capable of supporting its weight. Carpeting must be
removed from the floor area that the dryer is to rest on.
IMPORTANT: “The dryer must be installed on noncombustible floors only.”
2. The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.
3. The dryer is for use in noncombustible locations.
4. Provisions for adequate air supply must be provided as noted in this manual (refer to Fresh Air Supply
Requirements in Section D).
5. Clearance provisions must be made
from combustible construction as noted
in this manual (refer to Dryer
Enclosure Requirements in Section
C). Even though a 12-inch (30.48 cm)
clearance is acceptable, it is
recommended that the rear of the dryer
be positioned approximately 2 feet (0.61
meters) away from the nearest
obstruction (i.e., wall) for ease of
installation, maintenance, and service.
(Refer to the illustration at right.)
6. Provisions must be made for adequate
clearances for servicing and for
operation as noted in this manual (refer
to Dryer Enclosure Requirements
in Section C).
7. Dryer must be exhausted to the
outdoors as noted in this manual (refer
to Exhaust Requirements in Section
E).
8. Dryer must be located in an area where correct exhaust venting can be achieved as noted in this manual
(refer to Exhaust Requirements in Section E).
IMPORTANT: Dryer should be located where a minimum amount of exhaust duct will be necessary.
9. The dryer must be installed with a proper exhaust duct connection to the outside.
Summary of Contents for AD-236
Page 26: ...22 American Dryer Corp 113047 21...
Page 48: ...ADC Part No 113047 21 11 13 15...
