Lens Focusing
1. Hang fixture in its final position
2. Set Function DIP switch #6 to on.
3. Projector shutter will open and Pan and Tilt will be set to center and Gobo will be set to “small
spot”
4. Use a screwdriver to loosen the silver retaining screw .
5. Adjust lens until sharp focus is obtained.
Warning. Tighten screw securely.
If screw Is not tight, the lens tube could slide out of the
fixture, causing equipment damage and or personal injury.
S e c t i o n 2
DMX512 Operation
I. Connect the
X-Treme™ fixture to the X-Treme/C™, X-Treme/19C™ or any suitable DMX-512
controller with a 3 pin XLR data cable.
2. Continue to connect together all the fixtures using 3 pin XLR data cables.
3. Set the DMX address for each fixture using the 9 pin DIP switch on the back panel fixture.
Each fixture uses 4 DMX-512 channels;
CH1: Color, CH2: Gobo 1; CH3: Pan; CH4: Tilt
You must select the proper DMX-512 address for each X-Treme™ projector.
Below Is a chart of standard addressing for use with the X-Treme/C™ ,X-Treme/19C™ controllers.
DIP switch setting
Projector
DIP switch setting
Projector
1
9
1 2 3 4 5 6 7 8 9
2
1 2 3 4 5 6 7 8 9
10
1 2 3 4 5 6 7 8 9
3
11
1 2 3 4 5 6 7 8 9
4
12
1 2 3 4 5 6 7 8 9
5
1 2 3 4 5 6 7 8 9
13
6
14
7
15
8
16
1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8 9
9
1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
on
on
on
on
on
on
on
on
on
on
on
on
on
on
on
on
X-Treme™ User Instructions page 3
DMX-512 Addressing
