S e c t i o n 1
Inspection
Every X-Treme™ projector was thoroughly tested and shipped in perfect condition. Carefully unpack
the projector and remove the bag with components from the carton. Inspect equipment for shipping
damage.
Packing list:
1
.
X-Treme™ Projector
2. IEC power cord
3. Operating manual
4. MC-10 XLR female to male 10ʼ cable
L
amp Installation
Caution! Extremely hot! Always allow unit to cool before re-lamping
1. Loosen thumbscrews on back of unit. Slide out the lamp holder assembly.
2. Remove lamp from original packaging. Read the enclosed instructions. Lamp is
included with X-Treme™ Projector Do not touch glass with bare hands as this
could damage the lamp.
3. Fit lamp Into holder
4. Slide lamp holder assemble back Into unit.
5. Tighten retaining screws
Projector Installation
1. Unit can be hung In any position.
2. Make sure to use a minimum 35Kg rated clamp.
3. Allow enough space on all sides for proper cooling.
4. Connect IEC power cord to back of unit.
5. Plug cord into property grounded socket.
*
Check that the voltage marked on the back of unit is correct for your area.
6. Lamp will light and unit will reset and wait for signal from controller.
*
The shutter is closed in stand-by mode, so it will be difficult to tell if the lamp is
lit without a controller.
*
Unit may make smoke for a few minute until dust and excess paint is burned off by the lamp.
Precautions:
1.Never operate unit when case is open.
2.Never cover unit as this may block air vents and cause overheating and
possible fire hazard.
3. Never operate unit in the rain or in damp moist conditions as this could
cause electric shock.
4. Follow standard electrical safety precautions when installing, operating or
servicing the unit to prevent electrical shock, fire, or equipment damage.
5.These units are for commercial use and contain no user-serviceable parts inside.
Servicing must be conducted by qualified service personnel.
X-Treme™ User Instructions page 2
Getting Started
