ADJ Products, LLC - www.adj.com - WiFly Bar RGBA User Manual Page 13
ADJ Products, LLC - www.adj.com - WiFly Bar RGBA User Manual Page 14
WiFly Bar RGBA Operating Instructions
3. Press the UP or DOWN buttons to either activate the remote func-
tion (On) or deactivate it (Off).
WiFLY Address:
This function is used to set the WiFly address. This address must
match the address that is set to WiFly transceiver or WiFly controller.
1. Plug the fixture in and press the MODE button until “rcXX” is dis-
played. “XX” represents a number between 00-15.
2. Press the UP or DOWN buttons to select your desired address.
Remember, the address must be the same as WiFly transceiver or
WiFly controller.
Battery Life:
This menu is used to check/display the battery life.
1. Plug the fixture in and press the MODE button until “bXXX” is dis-
played. “XXX” represents a number between 0-100. The number
that is displayed is the remaining battery life. If “b---” is displayed,
it means either the battery is dead or your running the unit on AC
power.
WiFly Bar RGBA Operating Instructions
1. This function will allow you to control each individual fixture’s
traits with a standard DMX 512 controller.
2. To run your fixture in DMX mode press the MODE button until
“d.XXX” is displayed. “XXX” represents the current displayed ad-
dress. Use the UP or DOWN buttons to select your desired DMX
address, then press the SETUP button to select your DMX
Channel mode.
3. Use the UP or DOWN buttons to scroll through the DMX Channel
modes. The Channel modes are listed below:
• To run the 4 Channel Mode, press the MODE button until “CH.04”
is displayed. This is the 4 Channel DMX Mode.
• To run the 6 Channel Mode, press the MODE button until “CH.06”
is displayed. This is the 6 Channel DMX Mode.
• To run the 7 Channel Mode, press the MODE button until “CH.07”
is displayed. This is the 7 Channel DMX Mode.
• To run the 8 Channel Mode, press the MODE button until “CH.08”
is displayed. This is the 8 Channel DMX Mode.
• To run the 9 Channel Mode, press the MODE button until “CH.09”
is displayed. This is the 9 Channel DMX Mode.
• To run the 10 Channel Mode, press the MODE button until
“CH.10” is displayed. This is the 10 Channel DMX Mode.
• To run the 18 Channel Mode, press the MODE button until
“CH.18” is displayed. This is the 18 Channel DMX Mode.
• To run the 34 Channel Mode, press the MODE button until
“CH.34” is displayed. This is the 34 Channel DMX Mode.
4. Please see pages 16-28 for DMX values and traits.
5. After you have chosen your desired DMX Channel mode plug in
the fixture via the XLR connections to any standard DMX control-
ler.
ADJ RFC:
This function is used to activate and deactivate the ADJ RFC (Remote
Control). When this function is activated you can control the fixture
using the ADJ RFC. Please see the next page for ADJ RFC controls
and functions.
1. Plug the fixture in and press the MODE button until “AUTO” is dis-
played.
2. Press the SET UP button until “rFXX” is displayed. “XX” repre-
sents either “on” or “oF”.
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 20 fixtures maximum. After 20 fixtures you will need
to use a new power outlet. They must be the same fixtures. DO
NOT mix fixtures.
NOTE: Fixtures cannot be power cord daisy chained and run by
battery power.
WiFly Bar RGBA Power Cord Daisy Chain
