©
American DJ
®
- www.americandj.com - Royal Sky Instruction Manual Page 12
©
American DJ
®
- www.americandj.com - Royal Sky Instruction Manual Page 11
System Menu: When confirming your setting press ENTER
and then hold MENU for at least 2-3 seconds, or you can
wait 1 minute for automatic setup. To exit without making
any adjustments press the MENU button.
Addr
-
DMX Address Setting
via control board -
1. Press the MENU button until “
Addr
” is displayed, press ENTER.
2. “
X
” will now be displayed, “X” represents the displayed address.
Press the UP or DOWN buttons to find your desired address.
3. Press ENTER to confirm, then connect your DMX controller.
NOTE: If after you connect your DMX controller the unit does not fall
into DMX mode, press and hold the MENU button for at least 3 sec-
onds.
SLNd -
This will let you set unit as a slave in a master/
slave configuration.
1. Press the MENU button until “
SLNd
” is displayed, press ENTER.
Either “
SL 1
” or “
SL 2
” will be displayed.
2. Press the UP or DOWN buttons until your desired setting is dis-
played, press ENTER to confim.
NOTE: In a Master/Slave configuration you can make one fixture the
Master and then set the next fixture to “SL 2”, the fixtures will now
have contrast movement to each other.
SHNd: SH
0
-
SH
18
-
Show modes 0-18 (Factory pro-
grams) Show Mode can run with or without sound active
mode on. With sound active mode on, the shows will tend to
run faster.
1
. Press the MENU button until “
SHNd
” is displayed, press ENTER.
2. “
SH
X
” will now be displayed, “X” representing a number between
0-18. Shows 1-18 are preprogrammed shows, while “
SH
0
” is random
show mode. Press the UP or DOWN buttons to find your desired
show.
Royal Sky System Menu
Royal Sky
System Menu
