American DJ
®
- www.americandj.com - Revo II™ Instruction Manual Page 11
American DJ
®
- www.americandj.com - Revo II™ Instruction Manual Page 12
Revo II™
Operation
Revo II™ Fuse Replacement
Revo II™
DMX Traits
3. The optional
UC3 Controller
(not included)
may be used to con-
trol different functions including blackout.
Master-Slave Operation (Sound Active):
This function will allow
you to link up to 16 units together and operate without a controller. The
units will be sound activated. In Master-Slave operation one unit will
act as the controlling unit and the others will react to the controlling
units programs. Any unit can act as a Master or as a Slave.
1. Using standard XLR microphone cables, daisy chain your units
together via the XLR connector on the rear of the units. Remem-
ber the Male XLR connector is the input and the Female XLR
connector is the output. The first unit in the chain (master) will use
the female XLR connector only - The last unit in the chain will use
the male XLR connector only. For longer cable runs we suggest a
terminator at the last fixture.
2. On the Master unit find your desired show and set that show by
pressiing the ENTER button.
3. On the slave units
tap the MENU button until “
SLND
” is dis-
played, and Press ENTER.
4. The slave units will now follow the Master unit.
5.
The optional
UC3 Controller
(not included)
may be used to con-
trol different functions including blackout.
First unplug the power. The fuse holder is located next to the power
cord. Using a flat-head screw driver unscrew the fuse holder. Remove
the bad fuse and replace with a new one.
Revo II™ UC3 Control
Blackout Blackout the unit
Function 1. Synchronous Strobe Chase
2. Sound Strobe (10 Chase)
3. Two Light Strobe
Mode Sound/Strobe Chase
(LED Off) (LED On)
Revo II™
Power Cord Daisy Chain
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 33 fixtures maximum. After 33 fixtures you will need
to use a new power outlet. They must be the same fixtures. DO
NOT mix fixtures.
