American DJ
®
- www.americandj.com - Revo II™ Instruction Manual Page 7
American DJ
®
- www.americandj.com - Revo II™ Instruction Manual Page 8
5-Pin XLR DMX Connectors.
Some manufactures use 5-pin XLR
connectors for DATA transmission in place of 3-pin. 5-pin XLR fixtures
may be implemented in a 3-pin XLR DMX line. When inserting stan-
dard 5-pin XLR connectors in to a 3-pin line a cable adaptor must be
used, these adaptors are readily available at most electric stores. The
chart below details a proper cable conversion.
Conductor
5-Pin XLR Male (In)
3-Pin XLR Female (Out)
Pin 1
Pin 5 - Do Not Use
Pin 4 - Do Not Use
Pin 3
Pin 2
Pin 1
Pin 3
Pin 2
Not Used
Not Used
Data True (+ signal)
Data Compliment (- signal)
Ground/Shield
3-Pin XLR to 5-Pin XLR Conversion
Revo II™
Set Up
Revo II™
System Menu
ADDR -
DMX Address Setting
.
1. Tap the either the MENU, UP, or DOWN buttons until “
ADDR
”
is displayed, press ENTER.
2. A number between 1-512 will be displayed and flashing.
Press the UP or DOWN buttons to find your desired address.
Press ENTER to set your desired DMX address.
SLND -
This will let you set unit as a master or slave in a
master/slave configuration.
1. Tap the either the MENU button until “
SLND
” is displayed,
press ENTER. “
MSTR
”, “
SL 1
” or “
SL 2
” will be displayed.
2. Tap the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim and exit.
SHOW -
in this mode the unit will run in sound active
show mode.
1. Tap the either the MENU button until “
SHOW
” is displayed,
press ENTER.
2. Tap the UP or DOWN buttons to scroll through 11 sound
active shows.
3. Select your desired chase by pressing the ENTER button to
confirm and exit.
BLND -
Blackout or Stand by mode.
1. Tap the either the MENU button until “
BLND
” is displayed,
press ENTER. Either Yes or No will be displayed.
2. To activate Blackout tap the UP or DOWN buttons until Yes is
displayed, press ENTER to confim and exit. The fixture will now
be in Blackout mode. To deactivate Blackout mode, select No
