ADJ Products, LLC - www.adj.com - Octo Beam WW Instruction Manual Page 16
ADJ Products, LLC - www.adj.com - Octo Beam WW Instruction Manual Page 17
Octo Beam WW 10 Channel Mode
Channel Value
Function
1 - 8
DIMMER
0 - 255 0% - 100%
9 MASTER DIMMER
0 - 255 0% - 100%
10 STROBING
0 - 15 NO FUNCTION
16 - 131 STROBING SLOW - FAST
132 - 139 NO FUNCTION
140 - 181 SLOW OPEN - FAST CLOSE
182 - 189 NO FUNCTION
190 - 231 FAST OPEN - SLOW CLOSE
232 - 239 NO FUNCTION
240 - 247 RANDOM STROBING
248 - 255 NO FUNCTION
Octo Beam WW Cleaning
Due to fog residue, smoke, and dust cleaning the internal and exter-
nal optical lenses must be carried out periodically to optimize light
output.
1. Use a soft cloth to wipe down the outside casing.
Cleaning frequency depends on the environment in which the fixture
operates (i.e. smoke, fog residue, dust, dew).
Listed below are a few common problems the user may encounter,
with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are
wired correctly (pin 3 is “hot”; on some other DMX devices
pin 2 may be ‘hot’). Also, check that all cables are connected
to the right connectors; it does matter which way the inputs
and outputs are connected.
Unit does not respond to sound:
1. Quiet or high pitched sounds will not activate the unit.
If problems are not resolved; Contact ADJ Products, LLC for service.
1-800-322-6337
Octo Beam WW Trouble Shooting
Octo Beam WW Fuse Replacement
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 12 fixtures maximum for 120V, and 19 fixtures maxi-
mum for 240V. After the maximum fixtures has been reached you
will need to use a new power outlet. They must be the same fix-
tures. DO NOT mix fixtures.
Octo Beam WW Power Cord Daisy Chain
Locate and remove the unit’s power cord. Once the cord has been
removed located the fuse holder located inside the power socket.
Insert a flat-head screw driver into the power socket and gently pry out
the fuse holder. Remove the bad fuse and replace with a new one. The
fuse holder has a built-in socket for a spare fuse be sure not to confuse
the spare fuse with active fuse.
