American DJ Octo Beam WW, User Instructions

Page: 6 / 10

ADJ Products, LLC - www.adj.com - Octo Beam WW Instruction Manual Page 11 ADJ Products, LLC - www.adj.com - Octo Beam WW Instruction Manual Page 10
2. Either “ON” or “OFF” will now be displayed. Press the UP or
DOWN buttons to select “ON” to keep the LED display on at all
times, or “OFF” to allow the LED display to turn off after 2 min-
utes. Press any button to turn the LED display on again.
3. Press ENTER to confirm your selection.
REV -
This function is used in conjuction with DMX
mode. The direction in which the projector lenses/LEDs
light up can be reversed so that the LED line up can start at
either end of the bar. This feature is useful when the unit is
installed in a reversed orientation so the unit itself does not
have to be uninstalled and reversed.
Example: When using 8 Channel mode (LED 1) can start at either
end of the bar depending on this functions set up.
1. Press the MENU button until “ REV ” is displayed, press
ENTER.
2. The display will show either “
YES” or “NO ”. Press the UP or
DOWN buttons to select “ YES ” which will have the projector
lenses/LEDs light up right to left, or “ NO ” which will have the
projector lenses/LEDs light up left to right.
3. Press ENTER to confirm.
DISP
- This will “flip” the LED display
1. Press the MENU button until “ DISP ” is displayed, press
ENTER.
2. When “
DISP ” is displayed the LED display will remain normal,
when “ DSIP ” is displayed, the LED display will be “flipped”.
Use the ENTER button to find your desired display set up, then
press MENU to confirm and exit.
TEST
- This function will run a self test program.
1. Press the MENU button until “ TEST ” is displayed, press
Octo Beam WW System Menu Octo Beam WW System Menu
1. Press the MENU button until “ SENS ” is displayed, press
ENTER.
2. The display will show a number between 0-100. Press the UP
or DOWN buttons to adjust the sound sensitivity. 0 being the
least sensitive and 100 the most sensitive.
3. Press the ENTER, and then press and hold the MENU button
for at least 3 seconds to confirm.
DNST
- This mode can be used as a precaution mode, that
in case the DMX signal is lost, the operating mode chosen in
the setup is the running mode the fixture will go into when
the DMX signal is lost. You can also set this as the operat-
ing mode you would like the unit to return to when power is
applied.
1. Press the MENU button until “ DNST ” is displayed, press
ENTER.
2. Either “
MAST ”, “ BLND ”, or “ LAST ” will be displayed. Choose
an operating mode you would like the unit to start up in when
power is applied or the DMX signal is lost.
• MAST (Master-Slave) - If the DMX signal is lost or power is
applied, the unit will automatically go into Master Slave mode.
• BLND (Blackout) - If the DMX signal is lost or power is applied,
the unit will automatically go into stand by mode.
• LAST (Last State) - If the DMX signal is lost the fixture will stay
in the last DMX set up. If power is applied and this mode is set,
the unit will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
LED
- With this function the LED display will turn off after
2 minutes.
1. Press the MENU button until “ LED ” is displayed, press ENTER.