Introduction:
Thank you for purchasing the
Mini Flame LED by
American DJ
®
. This unit
can only be set on a flat surface. For best
results, use a fog or haze machine to enhance the beam output.
Please read the following instructions before installing or operating
your new Mini Flame LED.
Operating Instructions: Plug the unit in to a matching power outlet
or into a power pack. The power switch is located on the bottom of
the fixture. Put the switch into the “On” position and the fixture will
start working automatically.
Mini Flame LED
Operation
Please carefully read and understand the instructions in this manual
thoroughly before attempting to operate this unit. These instructions
contain important safety information regarding the use and mainte-
nance of this unit. Please keep this manual with the unit, for future
reference.
Mini Flame LED
General Instructions
• Keep the outside of this device dry at all times. Do not spill water
or other liquids into or on to your unit. To prevent fire or shock
hazard, do not expose this product to rain or moisture.
• Be sure to save the packing carton in the event you may have to
return the unit for service.
• This unit is designed for interior use only. Do not use this unit out
doors. Use of product outdoors will void the warranty.
• Be sure that the local power outlet match that of the required vol-
tage for your unit.
• Do not attempt to operate this unit if the power cord has been
frayed or broken.
• Always route your power cord out of the way of foot traffic.
• Do not attempt to remove or break off the ground prong from the
electrical cord. This prong is used to reduce the risk of electrical
shock and fire in the rare case of an internal short.
• Disconnect the unit’s main power when left unused for long peri-
ods of time.
• Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6” (15cm) between this device and a wall.
• Never block the ventilation holes.
• Do not attempt to operate this unit, if it becomes damaged in any
way.
• Never operate this unit when it’s cover is removed.
• This unit is for adult use only. Keep out of the reach of children.
Mini Flame LED
Cleaning
©
American DJ Supply
®
- www.americandj.com - Mini Flame LED Instruction Manual Page 4
©
American DJ Supply
®
- www.americandj.com - Mini Flame LED Instruction Manual Page 3
Mini Flame LED
Precautions
If the silk drape becomes creased, you may iron the flame using a non-
drip iron on a low setting. Do not steam iron.
If the silk drape becomes frayed, you may use a sharp pair of scissors
to carefully cut the loose silk strands. The silk drapes may become
frayed after a period of four weeks.
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning should be carried out
periodically to optimize light output. Cleaning frequency depends on
the environment in which the fixture operates (I.e. smoke, fog residue,
dust, dew). In heavy club use we recommend cleaning on a monthly
basis. Periodic cleaning will ensure longevity, and crisp output.
Always be sure the unit is turned off and unplugged before perform-
ing any cleaning procedures.
1. Use normal glass cleaner and a soft cloth to wipe down the out-
side casing.
2. Use a brush to wipe down the fan grill.
3. Gently wipe down the LEDs with soft brush to remove all residue
and dust.
4. Always be sure to dry all parts completely before plugging the unit
back in.
Mini Flame LED
Silk Drape
