ADJ Products, LLC - www.adj.com - LED UV GO Instruction Manual Page 9
ADJ Products, LLC - www.adj.com - LED UV GO Instruction Manual Page 10
LED UV GO ADJ-RC1 Operation
The ADJ-RC1 infrared remote has many differnet functions and gives
you complete control of your Mega Tri 60. To control the your desired
fixture you must aim the controller at the front of the fixture and be
no more the 30 feet away. To use the ADJ-RC1 you must first activate
the fixtures infrared receiver, to activate the receiver please see the
instructions on page 10.
STAND BY
-
Pressing this button will blackout the fixture.
FULL ON
-
Hold this button down to fully light up the unit. When you
let the button go, the unit will return to its previous state.
COLOR
-
Press this button to enter Dimmer mode. Adjust the output
intensity using either the number buttons, or using the “”
and “DIMMER -” buttons.
STROBE
-
This button will activate the strobe effect. You can control
the flash rate by pressing the “” and “DIMMER -” buttons.
If you press and hold this button the unit will begin to strobe.
SPEED
-
Press this button and use the “+” & “-” buttons to adjust the
speed of the Auto run.
SOUND ON & OFF -
These buttons activate and deactivate the
sound active mode.
SHOW -
This designates the fixture as a slave fixture in a master/
slave configuration.
“” and “DIMMER -” -
Use these buttons to adjust the out-
put intensity and to adjust the strobe speed.
Battery Status:
This function is used to check the life status of the battery.
Plug the fixture in and press the MODE button until “BATT” is
displayed. Use the UP or DOWN buttons to scroll to “STAT” and
press ENTER. The number that is displayed is the remaining
battery life. Please do not let the battery fully die, this sever-
ly shortens the life of the battery.
Example: If “50” is displayed, the battery is at half life. If “25” is
displayed, the battery is at 25% life.
NOTE: When the battery is charging or if the battery life is
below 30% the digital display will flash.
Battery Recharge: To recharge the battery, plug the supplied AC
cord into the AC input on the side of the unit and plug the other
end into a matching power supply.
Press the MODE button until “BATT” is displayed, and press
ENTER.
Use the UP or DOWN buttons to scroll to the menu “CHAR”
then press ENTER.
Use the UP or DOWN buttons to scroll to “ON”, and press
ENTER. The after you select “ON” the battery is now being
charged. To stop charging the battery, select “OFF”.
If the battery is being charged, and the unit is not being used,
press the MODE button until “BATT” is displayed, and press
ENTER. Use the UP or DOWN buttons to scroll to “LOAD” and
press ENTER. Select “ON” to keep the LED on, or “OFF” to
blackout the unit.
It takes about 6 hours to reach full charge.
Note: When unplugging the unit from charging and then
applying power via battery, there will be a minimal charge
drop.
LED UV GO Battery Status & Charging
