ADJ Products, LLC - www.adj.com - Inno Color Beam Quad 7 User Manual Page 11
Back Light
- With this function you can make the back-
light automatically turn off after one minute.
1. Press the MENU button until “Back Light” is displayed, press
ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or
DOWN buttons to select “ON” to keep the backlight on at all
times, or “OFF” to allow the backlight to turn off after 2 minutes.
Press any button to turn the backlight on again.
3. Press ENTER to confirm.
Function Delay
- With this function the blackout func-
tion under 13 Channel mode can be delayed.
1. Press the MENU button until “Function Delay” is displayed,
press ENTER.
2. Either “No Delay” or time between 1s - 3s will be displayed.
This number represents the delay setting. Use the UP and DOWN
buttons to adjust the blackout delay.
Example: If the delay is set to 3 seconds, when you are in 13
Channel mode under DMX control, and the channel 12 values are
between 226-235, the fixture will move, and then blackout after
3 seconds.
3. Press ENTER to confirm.
White Balance
- With this function you can adjust the
RGB colors to make your desired color.
1. Press the MENU button until “White Balance” is displayed,
press ENTER.
2. Use the UP or DOWN buttons to find the color you wish to
adjust.
3. Once you find the color you want to adjust press ENTER, the
displayed value will begin to flash. Use the UP or DOWN but-
Inno Color Beam Quad 7 System Menu
Inno Color Beam Quad 7 System Menu
Sound State
- In this mode the unit will run in sound
active mode.
1. Press the MENU button until “Sound State” is displayed, press
ENTER.
2. Either “On” or “Off” will now be displayed. Use the UP or
DOWN buttons to toggle between “On” and “Off”.
3. Press ENTER to confirm your selection, the press and hold the
MENU button to activate.
Sound Sense
- In this mode you can adjust the sound
sensitivity of the sound active mode.
1. Press the MENU button until “Sound Sense” is displayed,
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (the lowest) and
100 (most sensitive).
3. Press ENTER to set you desired level.
Pan Inverse
- Pan Inversion
1. Press the MENU button until “Pan Inverse” is displayed,
press ENTER. Either “Yes” or “No” will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons
until “Yes” is displayed, press ENTER to confim. To deactivate
Pan inversion, select “No” and press Enter.
Tilt Inverse
- Tilt Inversion
1. Press the MENU button until “Tilt Inverse” is displayed, press
ENTER. Either “Yes” or “No” will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
until “Yes” is displayed, press ENTER to confim. To deactivate
Tilt inversion, select “No” and press Enter.
ADJ Products, LLC - www.adj.com - Inno Color Beam Quad 7 User Manual Page 10
