Inno Color Beam Quad 7 System Menu
2. “MODE X” will be displayed, “X” representing the displayed
dimmer mode. The modes are explained below.
Dimmer Mode 1 (Linear) - Steady, even increase in dimming.
Dimmer Mode 2 (Square Law) - Provides finer dimming control
near full intensity.
Dimmer Mode 3 (Inverse Square Law) - Provides finer dimming
control at lower intensities.
Dimmer Mode 4 (S-Curve) - Similar to Linear dimming with finer
dimming control at mid level intensities.
3. Press the UP or DOWN buttons to find your desired show
mode and press ENTER, then press and hold the MENU button
for at least 3 seconds to confirm.
Slave Mode -
This will let you set unit as a master or
slave in a master/slave configuration.
1. Press the MENU button until “Slave Mode” is displayed,
press ENTER. Either “Slave 1” or “Slave 2” will be displayed.
2. Press the UP or DOWN buttons until your desired slave mode
is displayed, press ENTER to confim.
NOTE: In a Master/Slave configuration you can make one fix-
ture the Master and then set the next fixture to “Slave 2”, the
fixtures will now have contrast movement to each other.
Black Out
- This will control blackout
1. Press the MENU button until “Black Out” is displayed, press
ENTER.
2. Either “Yes” or “No” will now be displayed. Press the UP or
DOWN buttons to toggle between “Yes” and “No”.
3. Press ENTER to confirm your setting.
ADJ Products, LLC - www.adj.com - Inno Color Beam Quad 7 User Manual Page 9
Inno Color Beam Quad 7 System Menu
DMX Address
-
Set the DMX Address -
1. Press the MENU button until “DMX Addresss” is displayed,
press ENTER.
2. “X” will now be displayed, “X” represents the displayed address.
Press the UP or DOWN buttons to find your desired address.
3. Press ENTER to confirm, and then press and hold the MENU
button
for at least three seconds
to assign.
Channel Mode
- This will let you select your desired
DMX Channel mode.
1. Press the MENU button until “Channel Mode” is displayed,
press ENTER.
2. “X Chan” will now be displayed, “X” represents the displayed
DMX channel mode; either 1 Channel Mode or 13 Channel Mode.
Press the UP or DOWN buttons to find your desired Channel
mode.
3. Press ENTER to confirm.
Show Mode
- Show modes 0 - 4 (Factory Shows).
1. Press the MENU button until “Show Mode” is displayed, press
ENTER.
2. “Show X” will now be displayed, “X” representing a number
between 1-4. Press the UP or DOWN buttons to find your desired
show and press ENTER to confirm.
3. Press and hold the MENU button for at least 3 seconds to
activate.
Dimmer Curve
- In this mode you can select the dimmer
curve.
1. Press the MENU button until “Dimmer Curve” is displayed,
press ENTER.
ADJ Products, LLC - www.adj.com - Inno Color Beam Quad 7 User Manual Page 8
