1. Channel 1 Output -
This outlet will control the operation of any
slave unit as channel one.
2. Channel 2 Output -
This outlet will control the operation of any
slave unit as channel two.
3. Channel 3 Output -
This outlet will control the operation of any
slave unit as channel three.
4. Audio Sensitivity Knob -
Turning the sensitivity knob in the clock-
wise direction will increase the sensitivity to sound. Turning the
knob in the counter clockwise direction will decrease the fixture’s
sensitivity to sound.
5. Microphone -
This mic receives external low frequencies to trigger
the unit.
6. Dip Switches -
These switches are used to set the DMX address.
Each switch corresponds to a specific value based on binary code.
See page 6 for a detailed explanation of DMX binary code.
7. XLR Input Jack -
This jack is used to accept an incoming DMX
signal.
8. XLR Output Jack -
This jack is used to send the incoming DMX
signal to another DMX fixture.
9. Fuse Holder -
This housing stores the 5 amp GMA protective
fuse. Always replace with the exact same type fuse, unless other-
wise instructed to do so by an authorized American DJ service tech-
nician.
10. Power Cord -
Connect only to a matching power outlet. Never use
this fixture if the ground prong has been removed or broken off.
FAB 4™
Controls and Functions
Universal DMX Control:
The FAB 4™ not only synchronizes
your 4 lights together to create an intense light show, it also incorpo-
rates DMX technology to call up individual programs when using any
type of universal DMX Controller such as the American DJ
®
DMX
Operator™ or Show Designer.™ The use of a DMX controller will allow
you to create your own programs tailored to your own needs. In DMX
mode you can also have the units run in sound active mode. The
“master” unit comes with four sound-active, built-in programs. You can
run any of the four programs or set the “master” to run through all four.
See page 14 for the various DMX traits including program settings.
1. The FAB 4™ uses a single DMX channel, please see page 14 for
detailed description of the DMX traits.
2. To run your fixture in DMX mode, plug in the fixture via the
XLR connections to any universal DMX controller. Follow the
set-up specifications that come with the controller.
3. Use your controller to control the various fixture traits.
4. This will allow you to create your own programs.
5. When using a DMX controller and setting up for DMX operation
follow follow the standard DMX Binary Code for a one channel
unit. See page 6.
6. For help running in DMX operation consult the manual that comes
with your DMX controller.
7. For longer cable runs we suggest using a terminator on the last
fixture.
FAB 4™
Operation
1
3
2
ON
1 2 3 4 5 6 7 8 9 10
9
8
7
6
5
4
10
©
American DJ Supply
®
- www.americandj.com - FAB 4™ Instruction Manual Page 7
©
American DJ Supply
®
- www.americandj.com - FAB 4™ Instruction Manual Page 8
ON
1 2 3 4 5 6 7 8 9 10
DMX Controller Operation
To DMX Controller Output
