ADJ Produc
t
s, LLC - www.adj.com - Event Bar Pro Instruction Manual Page 13
ADJ Produc
t
s, LLC - www.adj.com - Event Bar Pro Instruction Manual Page 12
• Blackout - If the DMX signal is lost or power is applied, the unit
will automatically go into stand by mode.
• Last State - If the DMX signal is lost the fixture will stay in the
last DMX set up. If power is applied and this mode is set, the unit
will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
Back Light
- With this function you can make the back-
light automatically turn off after one minute.
1. Press the MENU button until “Back Light” is displayed, press
ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or
DOWN buttons to select “ON” to keep the backlight on at all
times, or “OFF” to allow the backlight to turn off after 2 minutes.
Press any button to turn the backlight on again.
3. Press ENTER to confirm.
Auto Test
- This function will run a self test program.
1. Press the MENU button until “Auto Test” is displayed, press
ENTER.
2. The fixture will now run a self test. Press the MENU button to
exit.
Pan Invert
- Pan Inversion
1. Press the MENU button until “Pan Invert” is displayed, press
ENTER. Either “Normal” or “Inverse” will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons
until “Inverse” is displayed, press ENTER to confim. To deacti-
vate Pan inversion, select “Normal” and press Enter.
Tilt Invert
- Tilt Inversion
1. Press the MENU button until “Tilt Invert” is displayed, press
ENTER. Either “Normal” or “Inverse” will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
until “Inverse” is displayed, press ENTER to confim. To deacti-
vate Tilt inversion, select “Normal” and press Enter.
Fixture Time
- With this function you can display the
running time of the unit.
1. Press the MENU button until “Fixture Time” is displayed,
press ENTER.
2. The running time of the fixture will now be displayed. Press
MENU to exit.
Firmware Version
- This will display the software ver-
sion
1. Press the MENU button until “Firmware Version” is displayed.
Press the ENTER button and the software vesion will be dis-
played.
2. Press the MENU button to leave this function.
Reset
- Use this function to reset the unit.
1. Press the MENU button until “Reset” is displayed, press
ENTER.
2. The fixture will now reset.
Event Bar Pro
System Menu
Event Bar Pro
System Menu
