©
American DJ
®
- www.americandj.com - Emerald Scan II Instruction Manual Page 8
©
American DJ
®
- www.americandj.com - Emerald Scan II Instruction Manual Page 7
Emerald Scan II
Laser Warninig Labels
Emerald Scan II
Control & Functions
1. Power Switch -
This switch will control the unit’s main power.
2. Power Cord/Breaker -
Connect only to a matching power outlet.
Never use this fixture is the ground prong has been removed or broken
off. A 2A built-in safety breaker to reduce the risk of electrical shock
or fire and protect the circuitry. In the case of a internal short or power
surge.
3. XLR Input Jack -
This jack is used to accept an incoming DMX
signal or Master/Slave signal.
4. XLR Output Jack -
This jack is used to transmit the incoming
DMX signal to another DMX fixture, or transmit a Master/Slave signal
to the next Emerald Scan II in the chain. For best results in DMX or
Master/Slave mode terminate this jack if it is the last unit in the chain.
See “Terminator” on page 9.
5. BC 30 Controller Jack -
This jack is for use with the optional BC
30 controller only. Do not attempt to connect an audio signal to this
jack, this will damage the PC board and void your manufactures war-
ranty!
6. Dip Switches -
These switches serve two functions. In DMX mode
each switch corresponds to a specific value based on binary code.
See page 8 for a detailed explanation of DMX binary code.
7. Microphone -
This microphone receives external low frequencies
to trigger the unit in Sound-Active mode. This microphone is designed
to receive low frequency sounds only, tapping on the microphone and
high pitch sounds may not trigger the unit.
1
6
7
4
3
2
5
