©
American DJ
®
- www.americandj.com - DJ Spot 300 Instruction Manual Page 11
5-Pin XLR DMX Connectors.
Some manufactures use 5-pin XLR
connectors for DATA transmission in place of 3-pin. 5-pin XLR fixtures
may be implemented in a 3-pin XLR DMX line. When inserting stan-
dard 5-pin XLR connectors in to a 3-pin line a cable adaptor must be
used, these adaptors are readily available at most electric stores. The
chart below details a proper cable conversion.
Conductor
5-Pin XLR Male (In)
3-Pin XLR Female (Out)
Pin 1
Pin 5 - Do Not Use
Pin 4 - Do Not Use
Pin 3
Pin 2
Pin 1
Pin 3
Pin 2
Not Used
Not Used
Data True (+ signal)
Data Compliment (- signal)
Ground/Shield
3-Pin XLR to 5-Pin XLR Conversion
DJ Spot 300
Set Up
©
American DJ
®
- www.americandj.com - DJ Spot 300 Instruction Manual Page 12
DJ Spot 300
System Menu
On-Board System Menu.
The DJ Spot 300 comes with an easy to
navigate system menu. This next section will detail the functions of
each command in the system menu. You can leave any menu setting
without making any changes by pressing the ESC (ESCAPE) button.
MAIN MENU -
A.001
-
DMX Address Setting
1. Press the ESCAPE button until “
A.001
” is displayed. Press the
ENTER button to adjust the DMX address.
2. Tap the UP or DOWN button until the address that you want
is displayed, press the ENTER button.
TEST
-
This function will activate the internal test modes.
1. Press the ESCAPE (ESC) button until “
A.001
” is displayed.
Then press the UP button until “
TEST
” is displayed. Press the
ENTER button to choose a test mode.
AUDI
- This function is the Sound Active mode.
1. Press the ESCAPE (ESC) button until “
A.001
” is displayed.
Then press the UP button until “
AUDI
” is displayed. Press the
ENTER button.
2. Press the UP button to display “
YES
”. Press ENTER to con-
firm.
3. You can adjust the audio sensitivity of the unit by turning the
audio sensitivity knob clockwise, located in the rear.
Note: When the unit is in Sound Active mode, “test run” will
continuously flash on the LCD screen.
RPAN
-
The movement of the Pan will be reversed.
1. Press the ESCAPE (ESC) button until “
A.001
” is displayed.
Then press the UP button until “
R.PAN
” is displayed.
