fect tweaks the original sound to add different tonal definition. The effect is almost the same as
the PHASE effect.
ECHO EffECT -
This button is used to activate and deactivate the Echo effect. The Echo effect
adds an echo to your output signal. See built in effects on page 32.
TRANS EffECT -
This button is used to activate and deactivate the Trans effect. The Trans
effect simulates a real-time mixer transformer effect. See built in effects on page 33.
SkID BUTTON -
This button is used to activate and deactivate the Skid effect. The Skid effect
simulates the sudden platter stop of a turntable, like pressing the stop button on a turntable.
HOLD BUTTON -
This button has two functions:
parameter Lock:
This button allows you to lock any new parameter settings you set to the ef-
fects. The button LED will glow red when the hold function is not selected. When the hold
selection is not active, any changes to the effect parameters will be momentay.
System Lock:
If you press and hold the button for 5 seconds you will activate the System
Lock. The button LED will flash when the HOLD function is active. To unlock the HOLD function
press and hold the button for 5 seconds.
pHASE BUTTON -
This button is used to activate and deactivate the Phase effect. The Phase
effect tweaks the original sound to add different tonal definition. The effect is almost the same
as the FILTER effect.
fLANgER EffECT -
This button is used to activate and deactivate the Flanger effect. The
Flanger effect distorts the output signal and creates an effect similar to the frequency phasing in
and out of each other.
pAN EffECT -
This button is used to activate and deactivate the Trans or Pan effect. The Pan
effect allows you to pan the output from the left channel to the right channel. See built-in effects
on page 33.
REVERSE -
This button activates reverse play mode This function will play your track or sample
in reverse. All pitch and effect functions will operate normally in this mode
27. SAmpLE BUTTON -
This button is used to set and store a sample. Press this button and then
press your desired Bank Button (28) to set the sample loop mode, the button LED will glow. When
sample mode is set, the sampler will mix the music together. Press the Sample button again to set the
sample single mode (LED is flashing). Press the Sample button again to cancel the sample function.
28 BANk BUTTONS 1-4 -
These buttons are used to store either four (4) cue points or four (4) sam-
ples. Each Bank Button can store either a sample or a cue point. To play your programmed samples,
press the
Sample Button (27)
and then press the
Bank program Button
.
29. BANk pROgRAm BUTTON -
This function will allow you to program a sequence of up to 12
saved samples. See page 25 for more information.
30. mEmORY BUTTON -
This button can be used in a couple ways:
Press this button to activate the Memory mode, the memory button LED will glow when active. After
the memory mode is activated, press your desired
Bank Button (28)
to store your CUE point or playing
loop. See Using Built In Sampler on page 23.
To store your loops and cue points that are saved in the BANKS to the system memory for next time,
press the MEMORY button for 1 second.
31. pARAmETER TImE kNOB -
This knob is used to adjust the parameter time value. You can also
gENERAL fUNCTIONS AND CONTROLS (Cont.)
©
American Audio
®
- www.AmericanAudio.us - Radius 3000™ Instruction Manual Page 13
