1. FEATHER FADER PLUS™ CROSSFADER - Blends the output signals of any channels assigned to "X"
or "Y." When the fader is in the full "X" position, the output signal of any channels assigned to "X" will be
controlled by the master volume level. The same fundamentals will apply for "Y." Sliding the fader from
one position to another will vary the output signals of the "X" and "Y" channels respectively. When the
crossfader is set in the center position, the output signals of both the "X" and "Y" channels will be even.
2. HEADPHONES JACKS - These jacks are used to connect your headphones to the mixer. Use head-
phones only rated at 8 ohms to 16 ohms. Most DJ headphones are rated at 16 ohm, these are highly
recommended. Two different headphone jacks are conveniently located on the mixer, one on the face and
one on the front side panel. Always be sure the Cue Level Volume (6) is set to minimum before you
put the headphones on.
3. FADER ASSIGN BUTTONS - These buttons are used to assign a channel to the crossfader. When a
channel is assigned to "X," the left side (X-side) of the crossfader will control that channels output level.
The "Y" assign works in the same fashion. When a channel is assigned to neither "X" nor "Y" the output
volume will only be controlled by the channel's fader level. These button also function as a "TRANS
EFFECT" A Trans Effect is an effect similar to cutting the output signal with your transformer switches.
©
American DJ Supply
®
- www.americandj.com - Q-MX2 BPM User Instructions page 4
15
11
3
4
14
21
22
20
1
2
2
12
17
18
16
19
5
7
8
6
9
10
FRONT PANEL - CONTROLS AND FUNCTIONS
13
23
