American Access XM, Installation Manual

Page: 27 / 39

27
Turnback Platform
To build a 5 X 8 turnback platform you will use two (2) 4 X 5 platforms joined together.
Set up both platforms as normal with the legs set at the required height.
•
The platforms will be joined by putting the male end of one platform into the female groove of the second platform.
•
Where the joint comes together, install the legs so that the foot pad faces under and away from the other platform
leg. This will keep the foot pads from fighting for the same space when joined. ( VIEW 4)
(VIEW 4)
Install Note : There will NOT be a female
groove to attach the ramp coming DOWN
and UP from the platform.
When this occurs,
•
Install SUPPORT legs on the UP and
Down section of ramps where it butt
against the platform and push up tight to
the platform.
•
Install the 3” x 32” bridge plate over the
seam where the ramp and platform meet
A 5 x10 platform can be built using two (2)
5 X 5 platforms in the same manner.
Bridge plates
Legs
F
E
M
A
L
E
E
ND
M
A
L
E
E
ND