AMD Geode™ SC1200/SC1201 Processor Data Book
293
Core Logic Module - USB Controller Registers - PCIUSB
32579B
3
Read: PortOverCurrentIndicator.
This bit reflects the state of the OVRCUR pin dedicated to this port. This field is only
valid if NoOverCurrentProtection is cleared and OverCurrentProtectionMode is set.
0: No over-current condition.
1: Over-current condition.
Write: ClearPortSuspend.
Writing a 1 initiates the selective resume sequence for the port. Writing a 0 has no effect.
2
Read: PortSuspendStatus.
0: Port is not suspended.
1: Port is selectively suspended.
Write: SetPortSuspend.
Writing a 1 sets PortSuspendStatus. Writing a 0 has no effect.
1
Read: PortEnableStatus.
0: Port disabled.
1: Port enabled.
Write: SetPortEnable.
Writing a 1 sets PortEnableStatus. Writing a 0 has no effect.
0
Read: CurrentConnectStatus.
0: No device connected.
1: Device connected.
If DeviceRemoveable is set (not removable) this bit is always 1.
Write: ClearPortEnable.
Writing 1 a clears PortEnableStatus. Writing a 0 has no effect.
Note:
This register is reset by the UsbReset state.
Offset 5Ch-5Fh
HcRhPortStatus[3] Register (R/W)
Reset Value = 00000000h
31:21
Reserved.
Read/Write 0s.
20
PortResetStatusChange.
This bit indicates that the port reset signal has completed.
0: Port reset is not complete.
1: Port reset is complete.
19
PortOverCurrentIndicatorChange.
This bit is set when OverCurrentIndicator changes. Writing a 1 clears this bit. Writing
a 0 has no effect.
18
PortSuspendStatusChange.
This bit indicates the completion of the selective resume sequence for the port.
0: Port is not resumed.
1: Port resume is complete.
17
PortEnableStatusChange.
This bit indicates that the port has been disabled due to a hardware event (cleared PortEna-
bleStatus).
0: Port has not been disabled.
1: PortEnableStatus has been cleared.
16
ConnectStatusChange.
This bit indicates a connect or disconnect event has been detected. Writing a 1 clears this bit.
Writing a 0 has no effect.
0: No connect/disconnect event.
1: Hardware detection of connect/disconnect event.
If DeviceRemoveable is set, this bit resets to 1.
15:10
Reserved.
Read/Write 0s.
9
Read: LowSpeedDeviceAttached.
This bit defines the speed (and bud idle) of the attached device. It is only valid when
CurrentConnectStatus is set.
0: Full speed device.
1: Low speed device.
Write: ClearPortPower.
Writing a 1 clears PortPowerStatus. Writing a 0 has no effect.
Table 6-42. Memory Offset: USB Controller Registers (Continued)
Bit
Description
Summary of Contents for Geode SC1200
Page 8: ...8 AMD Geode SC1200 SC1201 Processor Data Book List of Figures 32579B...
Page 16: ...16 AMD Geode SC1200 SC1201 Processor Data Book Overview 32579B...
Page 24: ...24 AMD Geode SC1200 SC1201 Processor Data Book Architecture Overview 32579B...
Page 364: ...364 AMD Geode SC1200 SC1201 Processor Data Book Debugging and Monitoring 32579B...