Ambrell 3542, Manual

Page: 46 / 75

Technical Information 46
Precision Induction Heating
A
MBRELL
®
Doc#801-9526-00.doc
To Configure the EASYHEAT
If the converter kit (PN 305-0247) has been purchased and installed , follow these
steps to prepare your E
ASY
H
EAT
to make use of the serial communication option.
Case: You employ the serial port to monitor and control heat-cycle times in your process
Do this... Observe...
 select ►
System Options
then

 press ▲ / ▼ until...
 select
RS485 4 Wire
to enable the serial
communications feature; after this step, the port is
activated, but you must take the next steps to
enable serial
Start From
and
Control From
 press ▲ / ▼ until...
 once this selection has been made, press ▲
 press ► to select Terminal Mode
 select ▲ for addressing (default = 1)
 press ► to modify; 1-32 valid, 0 used for
broadcast; cannot be selected as address
 select ▲ to select
baud rate
 press ► to modify; (default = 38400; max
115,200)
 select ▲ to select
Start From
 press ► to select
RS485 4 Wire
 select ▲ to select
Control From
 press ► to select
RS485 4 Wire
 complete wiring per previous guide:
Menu Selection
► System Options
Communication
► RS485 4 Wire
Com Protocol
► Terminal Mode
Start From
► RS485 4 Wire
Control From
► RS485 4 Wire
RS485 Baud Rate
► 38400
RS485 Address
► 1
Serial communication with E
ASY
H
EAT
takes place when Home zone is displayed;
while in Control mode, the EASYHEAT will not respond to all serial commands.